Abstract:The interlayer mechanical properties of composite asphalt pavement structure based on the base surface morphology of a concrete surface, adhesive layer material, working environment, and other factors are complex. As discussed, the field of mass production samples, combined with laboratory shear tests, confirms the rationality of shear test in the composite interlayer shear strength evaluation, presents the composite shear strength test method of the interlayer and corrected maximum interlaminar shear strength calculation formula, further introduces the evaluation method of anti-shear strength of composite pavement, and verifies the feasibility of the method based on the results that should be used for the project compared with the surface by sandblasting and chiseling treatment, adhesive layer material, working temperature, molding method, loading method, degree of pollution, and other factors on the interface shear strength of the adhesive layer. Results indicate that the surface roughness, temperature, test factors of molding methods, loading rate, and interlayer contamination strongly influence the bonding performance between layers and in the construction of the best texture depth value and maximum shear strength between layers. The best interface texture depth is decided by the factor waterproof bonding layer type, interface roughness method, and base geometry node of the base surface. The shear performance of SBS asphalt Synchronous Crushed Stone Seal Coat interlayer sensitivity to temperature is greater than that of polymer reaction-type waterproof adhesive material. The maximum shear strength calculation formula was introduced in the special road section and temperature correction coefficient. The interlayer temperature is 40℃ when the shear strength between layers is the main control index. The calculation results and evaluation index of consistency, shear-stress test method, and system method interlaminar shear strength evaluation can be used for pavement structure design and performance evaluation.

Test Method on Adhesive Property of Joint Sealant in Supporting Layer of Ballastless Slab Track

Adhesive Characteristic and Mechanism of Ballastless Track Sealant in Hydrolysis Condition

Low-temperature Adhesive Properties of Sealant Applied in Ballastless Track under Shear Fatigue Loading

Developing Rules of Adhesive Properties and Mechanism of Ballastless-Track Sealants in Shear-Fatigue Loading

Study of accelerated ageing test methods of sealant applied in curtain wall

Study on mechanical properties of AR-SAMI

Development of a Modified Adhesion Test for Hot-Poured Asphalt Crack Sealants

Cohesive Property Evaluation of Crack Sealants Using a Low-Temperature Tensile Tester

Characterization of Hot-Applied Joint Sealants and Their Components in Terms of Their Chemical Composition and Basic Performance Properties

Experiment Analysis and Evaluation of Sealant

Study on the Cohesion and Adhesion of Hot-Poured Crack Sealants

Developing Rules of the Bonding and Micro Properties of Ballastless Track Sealants Under Ultraviolet Aging Environment

On-site testing method for tensile adhesive strength of existing curtain wall structural silicone sealant

Influence of Interfacial Parameters and Testing Methods on UHPC–NSC Bond Strength: Slant Shear Vs. Direct Tensile Testing

Study on testing method of shear modulus for adhesive

A Test Method to Evaluate the Adhesive Property between Asphalt and Aggregate Based on Simulating Actual Working Conditions

Mechanical and Functional Self-Healing Characteristics of Hot-Poured Crack Sealant Exploiting Dynamic Shear Rheometer and Low-Temperature Tensile Tester

Adhesive Bond Discrepancies Identification with Hybrid Dynamic Parameter Method

Long‐term performance of single‐lap joints: Review, challenges and prospects in civil engineering

Experimental study of strain rate effects on the strength of adhesively bonded joints after hygrothermal exposure

Test and Evaluation Method of lnterlaminar Shear Performance of Composite Pavement