Abstract:In recent years, precise metrology up to nanoscale has attracted substantial attention due to an increasing need for ultra-precision measurement systems for micro electro mechanical systems (MEMS) and nano electro mechanical systems (NEMS) calibration. In this paper, an analytical and numerical investigation for the proposed design of a 6-degree-of-freedom (6-dof) universal measurement system, using a relatively simple and inexpensive but highly sensitive set up, is presented. This system utilizes a convex mirror and two flat mirrors, one angled and one vertical, as targets to reflect laser beams onto photo detectors. These targets, placed on the object of interest for metrology applications, change the direction of the reflected beam when there is any movement in the object, which is detected by the photo detectors. The use of convex and angled mirrors greatly enhances the sensitivity of the system. Geometric relationships are established among all the optical components to predict the final intersection points of the laser beams reflected from the targets with the photo detector planes. These relationships are used to establish a Jacobian partial derivative matrix, which is further used to estimate the target pose when the photo detector outputs are given. Numerical simulation of the measurement process is performed using MATLAB®. Assuming the approximate distance from laser beam origin to target and the target to photo detector as 50 mm, and photo detector resolution as 0.1 µm, translations and rotations less than 50 nm and 2 arc sec, respectively, can be measured accurately. The highest amount of sensitivity in translation is obtained along the Z-axis with minimum a measurement of 3.4 nm; the highest amount of sensitivity in rotation is along the pitch-axis with a minimum measurement of 0.145 arc sec. The corresponding low sensitivity axes are X-axis and yaw-axis, with minimum measurements of 35 nm and 2 arc sec, respectively. The sensitivity and the resolution of the system can be increased many times further by increasing the curvature of the convex mirror or by increasing the distance between the target and the detectors. The analytical and simulation results of this work yield a scientific and engineering guideline for the development of meso, micro, as well as nanoscale metrology systems.

Measurement Uncertainty of Nano Bionix Universal Testing System

Uncertainty Evaluation and Optimization of INS Installation Measurement Using Monte Carlo Method

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

A study on mutative scale straightness measurement based on uncertainty analysis

Measurement uncertainty evaluation of a hexapod-structured calibration device for multi-component force and moment sensors

Measurement uncertainty in testing of biologicals in national control laboratories for ISO/IEC 17025: practical approaches

Uncertainty Experiment for Large Scale Measuring Equipment

Analysis of measurement uncertainty of a surface acoustic wave micro-pressure sensor

Measurement uncertainty assessment of articulated arm coordinate measuring machine for length measurement errors using Monte Carlo simulation

Research of the Atomic Force Microscopy Profilometer System

A hybrid total measurement uncertainty methodology for dual beam FIB/SEM metrology

Use of the Monte Carlo method for the estimation of measurement uncertainty in chemical analysis systems with intensive mathematical treatment

Position Measuring System in Metrological Atomic Force Microscope

The calibration and test about nanomechanical test equipment

Calculation of the Budget of Uncertainty on Measurements Size Nanoparticles Using Dynamic Light Scattering

Measurement and Control of Ambient Temperature for Metrological Atomic Force Microscope

Uncertainty Estimation in Measurement of Micromechanical Properties Using Random-Fuzzy Variables

Measurement uncertainty of plane-strain fracture toughness KIC testing by the Monte Carlo Method

AN ANALYTICAL DEVELOPMENT OF A UNIVERSAL DISPLACEMENT MEASUREMENT SYSTEM FOR ULTRA-PRECISION METROLOGY

Determination of measurement uncertainty by Monte Carlo simulation

Force calibration using errors-in-variables regression and Monte Carlo uncertainty evaluation