Abstract:An errors-in-variables regression method is presented as an alternative to the ordinary least-squares regression computation currently employed for determining the calibration function for force measuring instruments from data acquired during calibration. A Monte Carlo uncertainty evaluation for the errors-in-variables regression is also presented. The corresponding function (which we call measurement function, often called analysis function in gas metrology) necessary for the subsequent use of the calibrated device to measure force, and the associated uncertainty evaluation, are also derived from the calibration results. Comparisons are made, using real force calibration data, between the results from the errors-in-variables and ordinary least-squares analyses, as well as between the Monte Carlo uncertainty assessment and the conventional uncertainty propagation employed at the National Institute of Standards and Technology (NIST). The results show that the errors-in-variables analysis properly accounts for the uncertainty in the applied calibrated forces, and that the Monte Carlo method, owing to its intrinsic ability to model uncertainty contributions accurately, yields a better representation of the calibration uncertainty throughout the transducer’s force range than the methods currently in use. These improvements notwithstanding, the differences between the results produced by the current and by the proposed new methods generally are small because the relative uncertainties of the inputs are small and most contemporary load cells respond approximately linearly to such inputs. For this reason, there will be no compelling need to revise any of the force calibration reports previously issued by NIST.

Measurement uncertainty evaluation of a hexapod-structured calibration device for multi-component force and moment sensors

Calibration of 6-DOF Parallel Mechanism Using Joint Force Sensors

An Improved Kinematic Model for Serial Robot Calibration Based on Local POE Formula Using Position Measurement

Determination of measurement uncertainty by Monte Carlo simulation

The Device for Calibration Based on the Six-freedom of Generalized Force

Measurement uncertainty assessment of articulated arm coordinate measuring machine for length measurement errors using Monte Carlo simulation

Measurement Uncertainty of Nano Bionix Universal Testing System

An New Instrument for Measuring Mechanical Compliance of Micro-Systems

Force calibration using errors-in-variables regression and Monte Carlo uncertainty evaluation

Dynamic measuring of force-displacement-characteristics of shockmounts

Sensitivity and Uncertainty Analysis of Nonideal Calibration Standards for 16-Term Error Model

Comparison of Two Experiments Based on a Physical and a Torsion Pendulum to Determine the Mass Moment of Inertia Including Measurement Uncertainties

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Simulation and Modelling of a Precision Method for Static Low Force Measurement

Thermal deflection decoupled 6-DOF pose measurement of hexapods

Bayesian-based dynamic measurement uncertainty analysis of dynamic balancing machines

Model Based In Situ Calibration with Temperature compensation of 6 axis Force Torque Sensors

Optimized Design and Characterization of a Non-Linear 3D Misalignment Measurement System

Adaptive Monte Carlo applied to uncertainty estimation in a five axis machine tool link errors identification

Study on dynamic measurement uncertainty evaluation for CMMs

Vibration Measurements on a Six-Axis Collaborative Robotic Arm—Part I