Abstract:Diodes with an erbium and nitrogen codoped magnesium zinc oxide (MgZnO:Er,N) active layer were fabricated by spray pyrolysis on Si substrate with aqueous solutions including magnesium nitrate, zinc acetate, erbium acetate, ammonium acetate, and indium nitrate precursors. Diodes with different nitrogen content in their precursor were prepared and their properties were investigated. With scanning electron microscopy, film surface with mixed hexagonal flakes and tiny blocks was characterized for all samples. Certain morphologies varied for samples with different N contents. In the photoluminescence analyses, the intensity of the oxygen-related defects peak increased with the increasing of nitrogen content. The diodes were fabricated with an Au and In deposition on the top and backside. The diode current–voltage as well as capacitance–voltage characteristics were examined. An ununiformed n-type concentration distribution with high concentration near the interface in the MgZnO:Er,N layer was characterized for all samples. Diodes with high nitrogen content exhibit reduced breakdown voltage and higher interface concentration characteristics. Under reversed bias conditions with an injection current of 50 mA, a light spectrum with two distinct green emissions around wavelengths 532 and 553 nm was observed. A small spectrum variation was characterized for diodes prepared from different nitrogen content. The diode luminescence characteristics were examined and the diode prepared from N/Zn=1 in the precursor showed an optimal injection current-to-luminescence property. The current and luminescence properties of the diode were characterized and discussed.

Study of Er-doped Zinc Oxide Diode by Spray Pyrolysis

Thickness Study of Er-Doped Magnesium Zinc Oxide Diode by Spray Pyrolysis

Enhancing Light Emission of Zno Microwire-Based Diodes by Piezo-Phototronic Effect

On the Nitrogen Doping in Erbium and Nitrogen Codoped Magnesium Zinc Oxide Diode by Spray Pyrolysis

Anneal Effect Of Er Doped Zinc Oxide By Spray Pyrolysis

Optical properties of ITO/ZnO Schottky diode with enhanced UV Photoresponse

Low Driving Voltage and High Reliability 1.54 Μm Electroluminescence from SnO2:Er/p-Si Heterostructured Devices Via Energy Transfer Effect

Electroluminescence from light-emitting device with erbium-doped TiO2 film sputtered on p+-Si substrate: Enhancement effect of codoping zirconium

Study of Irradiation Induced Changes of Electrical and Functional Characteristics in Ge Doped Si Diodes

Photocatalytic Study of Zinc Oxide with Different Bismuth Doping

Properties of spray pyrolysis deposited Zr-doped ZnO thin films and their UV sensing properties

Synthesis and optical properties of phosphorus doped ZnO: X-ray absorption, X-ray emission, and X-ray excited optical luminescence studies

Effect of indium doping on zinc oxide films prepared by chemical spray pyrolysis technique

Enhanced ultraviolet photodetector based on Al-doped ZnO thin films prepared by spray pyrolysis method

Synthesis of N-Type ZrO2 Doped Ε-Ga2o3 Thin Films by PLD and Fabrication of Schottky Diode

Characterization of degenerate Zn-doped CdO thin films for optoelectronic devices

Nitrogen Plasma-Assisted Codoped P-type (In, N):SnO(2) Ultra-Fine Thin Films and N-ZnO/p-In:SnO(2) Core-Shell Heterojunction Diodes Fabricated by an Ultrasonic Spray Pyrolysis Method

Carrier concentration of calcium zinc oxide with different calcium contents deposited through spray pyrolysis

Inverted Structural Quantum Dot Light-Emitting Diodes Based on Al-doped ZnO Electrode.

Impact of Pd2+ and Sn4+ co-doping ZnO nanoflakes toward high-performing Schottky diode based on the generation of intermediate bands within the energy gap

ZnO with p-Type Doping: Recent Approaches and Applications