Abstract:Estimation of the stress distribution in ferromagnetic components is very important for evaluating the working status of mechanical equipment and implementing preventive maintenance. Eddy current testing technology is a promising method in this field because of its advantages of safety, no need of coupling agent, etc. In order to reduce the cost of eddy current stress measurement system, and obtain the stress distribution in ferromagnetic materials without scanning, a low cost eddy current stress measurement system based on Archimedes spiral planar coil was established, and a method based on BP neural network to obtain the stress distribution using the stress of several discrete test points was proposed. To verify the performance of the developed test system and the validity of the proposed method, experiment was implemented using structural steel (Q235) specimens. Standard curves of sensors at each test point were achieved, the calibrated data were used to establish the BP neural network model for approximating the stress variation on the specimen surface, and the stress distribution curve of the specimen was obtained by interpolating with the established model. The results show that there is a good linear relationship between the change of signal modulus and the stress in most elastic range of the specimen, and the established system can detect the change in stress with a theoretical average sensitivity of -0.4228 mV/MPa. The obtained stress distribution curve is well consonant with the theoretical analysis result. At last, possible causes and improving methods of problems appeared in the results were discussed. This research has important significance for reducing the cost of eddy current stress measurement system, and advancing the engineering application of eddy current stress testing.

Search the Stress Distribution for the Test Magnetic Field

Simulation of Magnetic Field Abnormalities Caused by Stress Concentrations

Research on Magnetic Testing Method of Stress Distribution

Investigation of Stress Concentration and Microdefect Identification in Ferromagnetic Materials within a Geomagnetic Field

Magnetic Signals of Stress Concentration Detected in Different Magnetic Environment

Characterization of Magnetic Field in Crack Propagation Stage and Application to Non-Destructive Evaluation

Magnetic Evaluation Method for Stress Annealing of Ferromagnetic Materials

Magnetic Field Properties Caused by Stress Concentration

Estimation of stress distribution in ferromagnetic tensile specimens using low cost eddy current stress measurement system and BP neural network

Quantitative Inversion of Stress and Crack in Ferromagnetic Materials Based on Metal Magnetic Memory Method

Magnetic Testing Method of Residual Stress Distribution by Geomagnetic Excitation

A numerical simulation method of residual magnetic field signals for evaluating deformation-induced stress concentration in ferromagnetic materials

Ferromagnetic Composite with Stress-Insensitive Magnetic Permeability: Compensation of Stress-Induced Anisotropies

Magnetic Field Aberration Induced by Cycle Stress

Progress in Nondestructive Evaluation of Stress Concentration with MMM Method

Effect of stress on the magnetic Barkhausen noise energy cycles: A route for stress evaluation in ferromagnetic materials

Effect of Stress on Variations in the Magnetic Field of Ferromagnetic Steel under a Constant DC Magnetic Field

Magnetization Changes Induced by Low Cycle Fatigue Both in the Geomagnetic Field and the Magnetic-Free Environment

Research on magnetoelastic coupling model based on magnetic dipole theory

Method of measuring the stress of ferromagnetic materials based on EMAT and magnetic Barkhausen noise characteristic parameters

A simplified multiscale magneto-mechanical model for magnetic materials