Abstract:Ferromagnetic materials are widely used in the manufacturing of key parts of energy equipment, due to their good mechanical properties, such as in nuclear power and pipes. Mechanical stress exists inside of these key parts during operation. Stress can be estimated indirectly by nondestructive testing methods that measure the magnetic flux leakage signals on the surface of the structure, which is of great importance for ensuring the safety of the equipment. However, the physical mechanism of the stress and magnetic field in the magnetization of ferromagnetic materials is still unclear, leading to limited applications of the technique in practice. In this paper, magnetization tests were carried out to investigate magnetization changes under the coupling effect of stress and a noncoaxial magnetic field. Two identical Q195 low-carbon steel specimens were tested. Specimen 1 was subjected to magnetic field values successively increasing from 0 A/m to 6000 A/m under constant uniaxial tension at different angles theta between the field and stress axis. Specimen 2 was subjected to the same magnetic field under different levels of stress at an angle of 0 degrees. The surface magnetic induction B of the specimens was measured and analyzed at each angle of stress-field orientation and at different levels of stress. It was found that there was a difference in the direction between the B and the magnetic field H at different angles theta. The magnetization curves correlated to the angle theta and the stress levels. The behavior of the derived maximum differential permeability and maximum magnetic induction could be used for the nondestructive evaluation of stress magnitude and direction in materials already in service.

Magnetic Testing Method of Residual Stress Distribution by Geomagnetic Excitation

Research on Magnetic Testing Method of Stress Distribution

Magnetomechanical Measurements for Nondestructive Evaluation of Failure in Steel Structural Element

Quantitative analysis of the relationship between non-uniform stresses and residual magnetizations under geomagnetic fields

Characterization of Magnetic Field in Crack Propagation Stage and Application to Non-Destructive Evaluation

Investigation of Stress Concentration and Microdefect Identification in Ferromagnetic Materials within a Geomagnetic Field

Relationship Between Magnetic Memory Signal and Stress

Magnetization Changes Induced by Stress Noncoaxial with the Magnetic Field in a Low-Carbon Steel

Study of magnetic signals behavior at groove defect by tensile stress during online measurement of Q345R steel

Stress State Detection Based on Metal Magnetic Memory Theory

Characterization of the Elastic-Plastic Region Based on Magnetic Memory Effect

Application of magnetic-elastic method in testing on welding residual stresses of model penstock and bifurcated pipe

Stress Measurement of Ferromagnetic Materials Using Hybrid Magnetic Sensing.

A numerical simulation method of residual magnetic field signals for evaluating deformation-induced stress concentration in ferromagnetic materials

Metal Magnetic Memory Inspection of Q345 Steel Specimens with Butt Weld in Tensile and Bending Test

Stress measurement using magnetic Barkhausen noise and metal magnetic memory testing

Plastic Stress Influences on the Magnetization of Ferromagnetic Steel in Geomagnetic field

Evaluation of Residual Stresses in Butt-Welded Joints by Residual Magnetic Field Measurements

Search the Stress Distribution for the Test Magnetic Field

A Steel Wire Stress Measuring Sensor Based on the Static Magnetization by Permanent Magnets

Method of measuring the stress of ferromagnetic materials based on EMAT and magnetic Barkhausen noise characteristic parameters