Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Comparative Study of Welding Deformation of a Stiffened Panel under Various Welding Procedures

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Reverse Deformation Design for Bending Control in Welding of Ring Stiffeners

The Influence of Welding Mechanical Boundary Condition on the Residual Stress and Distortion of a Stiffened-Panel

Prediction of Welding Deformation and Residual Stress in A Multiply-Stiffened Plate

The Influence of Welding-Induced 3D Residual Stress and Distortion on the Ultimate Strength of Multi-Stiffened Thin Plate Structures under Cyclic Load

Deformation rules of stiffened plates with continuous welding

Recent Research on Welding Distortion Prediction in Thin Plate Fabrication by Means of Elastic FE Computation

Study of Welding Inherent Deformations in Thin Plates Based on Finite Element Analysis Using Interactive Substructure Method

Evaluation Method for Inherent Deformation and its Application in Predicting Welding Distortion on Hull Blocks

Study on FEM Numerical Simulation Method for the Welding Distortion

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Research of Complicated Ship Structure Welding Distortion Based on ANSYS

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships

Determination of Welding Stress and Distortion in Discontinuous Welding by Means of Numerical Simulation and Comparison with Experimental Measurements

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Effect of Initial Deflection on Welding Induced Buckling Distortion of Stiffened Plate Structure

Numerical Prediction and Mitigation of Out-Of-Plane Welding Distortion in Ship Panel Structure by Elastic Fe Analysis