Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Research of Complicated Ship Structure Welding Distortion Based on ANSYS

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Study on FEM Numerical Simulation Method for the Welding Distortion

Design and Analysis of a Novel Ship Pipeline Welding Auxiliary Device

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Dimensional precision controlling on out-of-plane welding distortion of major structures in fabrication of ultra large container ship with 20000TEU

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Theoretical Prediction of Welding Distortion Considering Positioning And the Gap Between Parts

Welding distortions of huge structures controlled accurately through the numerical method and model experiment

Nonlinear Computational Welding Mechanics for Large Structures

Numerical Prediction of Welding Distortion Considering Gravity Force on General Ship Grillage Structure by Elastic Finite Element Method Using Inherent Strain

Predicting Residual Distortion of Aluminum Alloy Stiffened Sheet after Friction Stir Welding by Numerical Simulation

Welding Distortion Prediction of Ship Plate Frame Structures Based on a Self-Learning Database

Process optimization to control welding distortion of aluminum alloy train roof by high efficiency numerical simulation

Effect of Local Geometric Imperfections on Axial Buckling of Welded Steel Tanks

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Finite element analysis of the angular distortion and residual stress in underwater wet welding