Abstract:This paper describes the main results from an experimental investigation into the thermal stability of a cold-rolled Al–Y alloy. Tensile tests performed on specimens of the alloy and pure Al in annealed states reveal superior anti-softening properties of the former specimens relative to the latter counterparts. Origins of such thermal stability and underlying recovery and recrystallization kinetics are studied using electron microscopy and high energy X-ray diffraction (HEXRD) techniques. Microscopic observations reveal that recovery and recrystallization begin in the specimens of pure Al at a much lower temperature than in the specimens of Al–Y alloy. Onset of the recovery process in the Al–Y alloy is observed to begin with dislocation rearrangements in the β-Al3Y phases. The onset is followed by more substantial reduction in dislocation density, shrinkage of the β-Al3Y phases, and coarsening of the α-Al grains. The alloy contains stacking faults, which interestingly remain stable during the annealing treatments contributing to the thermal stability. The observed mechanisms are further confirmed by tracking the evolution of peaks under the in-situ synchrotron X-ray diffraction with heating. Onset of recovery was observed at 280 °C in both α-Al and β-Al3Y phases, while substantial shrinkage and spheroidization of β-Al3Y phases and decrease in dislocation density were detected at 400 °C causing loss of the alloy strength. Thermodynamic calculation showed that solubility of Y rapidly increases in α-Al at temperatures above 400 °C explaining the spheroidization and shrinkage of the β-Al3Y phases by diffusion of Y into the Al matrix.

Phase Constitution in Melt-Spun A1–10 Wt% Y

Structure, Properties and Response to Heat-Treatment of Melt-Spun Al-Y and Al-La Alloys

Ab-initio Study of Phase Stability, Elastic and Thermodynamic Properties of AlY Alloy under Pressure

Microstructure Evolution and Growth Behaviors of Faceted Phase in Directionally Solidified Al-Yalloys I. Microstructure Evolution of Directionally Solidified Al-15%Y Hypereutectic Alloy

The phase structure and electrochemical properties of the melt-spun alloy Zr0.7Ti0.3Mn0.4V0.4Ni1.2

Outstanding Thermal Stability of Cold-Rolled Al–Y Alloy Revealed Using In-Situ Synchrotron X-ray Diffraction and Ex-Situ Microscopy

Characterization of Phases in Mg–4Y–4Sm–0.5Zr Alloy Processed by Heat Treatment

Phase Transition of Al-Yb Alloy Films Upon Ion Irradiation and Thermal Annealing

Unveiling precipitation behavior in Mg-Y based alloys

Nano-yttrium-containing precipitates of T6 heat-treated A356.2 alloy when trace yttrium (Y less than 0.100 wt%) added

Microstructure and Phase Transformation of Forged Mg–3.7Zn–0.3Y–0.3Gd Quasicrystal Alloy

Structural hierarchy as a key to complex phase selection in Al-Sm

Precipitate Phases in the Mg-4Y-4Sm-0.5Zr Alloy

Yttrium incorporation in Cr2AlC: On the metastable phase formation and decomposition of (Cr,Y)2AlC MAX phase thin films

Effect of Yttrium on Microstructure and Mechanical Properties of ZAlSi7Mg Alloy

Investigation of Partitionless Growth Ofε-Al60sm11phase in Al-10 At% Sm Liquid

Simulation on Microstructure Evolution and Mechanical Properties of Mg−Y Alloys: Effect of Trace Y

Microstructure and crystallization of melt-spun Ti–Ni–Zr–Y alloys

A Near-bulk Quasicrystal Alloy Formed in Zn-Mg-Y System

The Thermal Properties of L12 Phases in Aluminum Enhanced by Alloying Elements

Phase Transformations in Yttrium –aluminium Oxides in Friction Stir Welded and Recrystallised PM2000 Alloys