Abstract:The WC-10％ Co (mass fraction) cemented carbides with flatter shape of WC custals were sintered at 1410 ℃ in the lowpressure vacuum sintering furnace with methods of one step carbonization and sintering using mixed precursor powders composed of ultratine yellow tungsten oxide,cobalt,carbon black and plate-like tungsten crystal seeds prepared by ball milling induction.The effects of flatter shape of tungsten 20％ (mass fraction) added on the microstructure and properties of WC-10％ Co cemented carbides were studied.The particle size and specific surface of powders were measured by Fisher sizer and specific surface equipment,the morphologies of powders and microstructures of sintered alloys were observed by scanning electronic microscope (SEM).The physical and mechanical properties of WC-10％ Co sintered composites were tested according to related material performance testing standard.The results showed that the microstructure of new cemented carbides with flatter shape of WC crystals prepared through precursor powders with flatter shape of tungsten crystal seeds produced by ball milling induction and hydrogen in-situ reduction assisted by carbon were different obviously with normal WC-Co alloy.Adding flatter shape of tungsten 20％,the WC grain size and coercive force of new cemented carbide were coarse and low,respectively,which was conducive not only to promoting the hardness,but also promoting the fracture toughness of the alloy owing to the special structure of coarse flatter shape WC grains and lots of ultrafine WC grains homogeneously embedded in cobalt binder phase.

Ultra-fine Grain Cemented Carbide Fabricated from WC-Co Composite Powder by In-situ Synthesis

Ultra-Coarse Grain Wc-Co Cemented Carbide From Chemical Coated Powder By One-Step Hydrogen Reduction

Synthesis of WC Composite Powder with Nano-Cobalt Coatings and Its Application in WC-4Co Cemented Carbide

Synthesis of WC-Co Composite Powder by Reduction and Carbonization Reactions and Its Densification

Preparation of Ultra-Fine WC-Co Cermet and Its Wear Behavior

Effect of Cobalt Content on the Microstructure and Mechanical Properties of Coarse Grained WC-Co Cemented Carbides Fabricated from Chemically Coated Composite Powder

Preparation of low binder WC-Co-Ni cemented carbides with fine WC grains and homogeneous distribution of Co/Ni

Rapid synthesis of ultrafine WC-Co cemented carbides by in-situ reactions and spark plasma sintering

WC-Co Cemented Carbide from Porous Spumous Cobalt Enwrapped WC Powders by Chemical Route

Preparation and Properties of WC-10％ Co Cemented Carbides with Flatter Shape of WC Grains

Microstructural Characterization of Nanostructured WC-Co Cemented Carbides

Effects of ultrafine WC on the densification behavior and microstructural evolution of coarse-grained WC-5Co cemented carbides

Synthesis and Characterization of WC-6Co Nanocrystalline Composite Powder

Ultrafine WC-10Co cemented carbides fabricated by electric-discharge compaction

Ultrafine/nano WC-Co Cemented Carbide: Overview of Preparation and Key Technologies

Preparation and Sintering of WC–Co Composite Powders for Coarse Grained WC–8Co Hardmetals

Synthesis of Ultrafine WC-Co Core-shell Composite Powders by Chemical Reduction Method

Effect of (V, Ti) (C, N) Composite Powders on the Properties of WC-8％Co Cemented Carbide

In-situ synthesis of WC–Co composite powder and densification by sinter-HIP

A Novel Route for the Synthesis of Ultrafine WC-15wt %co Cemented Carbides

Synthesis of WC-Co Composite Powders with Two-Step Carbonization and Sintering Performance Study