Abstract:A numerical model of the aluminium foam with voronoi cells is built and crushed with various velocities from 1m/s to 110m/s. It is shown that the foam deforms homogeneously within the whole specimen and the stress in the foam increases gradually with the strain without an obvious plateau stage under the low-velocity compression, while the deformation is concentrated within a zone near the impact end and an obvious plateau stage can be found in the stress-strain curves of the foams under the high-velocity crushing. The distribution of the density within the crushed foam is measured by the digital image processing. Accordingly, the distribution of the stress can be obtained based on the plastic constitution obtained from the experiments. It is shown that under the high-velocity crushing, the stress within the deformed zone decrease rapidly from the maximum lying at the impact end to the undeformed zone, and the higher the impact velocity is, the more nonuniformly the stress distributes. By measuring the average density of the deformed zone of the foam, the densification strain of the foams under dynamic crushing can be determined. Then combining the foam`s stress-strain curve under the low-velocity compression, the dynamic plateau stress of the foams can be predicted. It is shown that both the densification strain and the foams' dynamic plateau stress predicted by employing the digital image process technology are in good agreement with the numerical simulations. The results show that both the plateau stress and the densification strain of the foams increase with the impact velocity, which is essentially caused by the localization of the foam`s deformation under dynamic crushing.

Dynamic mechanical properties of aluminum alloy foams

Strain rate effects on the compressive property and the energy-absorbing capacity of aluminum alloy foams

Mechanical Properties of Aluminium Foam and How Density, Temperature, and Strain Rate Affect Dynamic Strain–Stress Relationship

Measurement of Dynamic Compressive Behavior of Aluminum-alloy Foams by Polycarbonate SHPB System

Influence of Strain Rate on the Mechanical Properties and Energy Absorption Capacity of Aluminum Alloy Foam

Dynamic mechanical properties of closed-cell aluminum foams with uniform and graded densities

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

Experiment research on the dynamic mechanical behavior of aluminum matrix syntactic foam

Experimental and Numerical Study on Strain Rate Effects of Close-Celled Aluminum Foams

Influence of Density on Compressive Properties and Energy Absorption of Foamed Aluminum Alloy

Rate-Dependent Constitutive Model Coupled with Temperature Softening for Open-Cell Aluminum Foam

Temperature Effects on the Mechanical Behavior of Aluminum Foam under Dynamic Loading

Compressive Properties and Energy Absorption of Aluminum Foams with a Wide Range of Relative Densities

Experimental Study of Aluminium Foams under Impact Loading

Numerical investigation of influences of porous density and strain-rate effect on dynamical responses of aluminum foam

Dynamic Deformability of Cell in Aluminum Foams

The Strain Rate and Density Dependence of the Mechanical Properties of Closed-Cell Aluminum Foam

Strain Rate Behavior of Closed-Cell Al-Si-Ti Foams: Experiment and Numerical Modeling

High Strain Rate Compression of Cenosphere-Pure Aluminum Syntactic Foams

Cell-size effect on mechanical properties of aluminum foams

Dynamic Behaviors Of Aluminum Foam Based On The New Empirical Constitution