Abstract:6-8 wt% yttria-stabilized zirconia (YSZ) has been widely employed as thermal barrier coating (TBC) to protect the high-temperature components of aero-engine and gas-turbine. However, the phase transition and sintering densification at high temperature seriously limit its application above 1200 °C. On account of this, CeO2 and Sc2O3 were doped into the YSZ by solid-state reaction sintering method in this paper. The effects of doping on the crystal structure, phase transition behavior and sintering resistance were investigated on the basis of XRD, Raman and FESEM, and the evolution of thermal properties of the ceramics was also analyzed. The results indicated that doped CeO2 increases the cell volume and tetragonal degree, but doped Sc2O3 was opposite. Co-doping caused not only significant difference in atomic mass and radius but also the formation of a large number of oxygen vacancies in the ceramics. Therefore, CeScYSZ showed the lowest thermal conductivity (1.53 W‧m−1‧K−1), which was about 23% lower than that of YSZ (2.00 W‧m−1‧K−1). More importantly, the oxygen vacancy also effectively stabilized the octet lattice, while the increase of lattice energy caused by Sc-O bond made it difficult for ions to misplace, which finally well prevented the transformation from t phase to m phase. There was no detrimental m-ZrO2 phase formation in the CeScYSZ after 120 h at 1500 °C. Besides, Co-doping could simultaneously overcome the poor sintering resistance caused by single CeO2 doping and the lower thermal expansion coefficient caused by single Sc2O3 doping, thus the CeScYSZ should be an ideal long-acting thermal protection material at higher temperatures.

Effect of doping CeO2 and Sc2O3 on structure, thermal properties and sintering resistance of YSZ

Investigation on the phase stability, sintering and thermal conductivity of Sc2O3–Y2O3–ZrO2 for thermal barrier coating application

Phase evolution and hot corrosion behavior of Yb2O3 and CeO2 co-doping YSZ ceramics under high temperature

Thermal and mechanical properties of Sc2O3–CeO2 co-stabilized zirconia ceramic as promising thermal barrier coating material

Effect of Sc2O3 Doping on YSZ TBCs: Morphologies, Phase Composition, Mechanical Properties, and High-Temperature Oxidation Resistance

Improved Properties of Scandia and Yttria Co-Doped Zirconia As a Potential Thermal Barrier Material for High Temperature Applications

Preparation, Thermophysical Properties, and Thermal Shock Resistance of Yb2O3-doped YSZ Coatings

Phase Composition and Stability, Sintering and Thermal Conductivity of Gd2O3 and Yb2O3 Co-Doped YSZ

Mechanical Properties Durability of Sc2O3-Y2O3 Co-Stabilized ZrO2 Thermal Barrier Materials for High Temperature Application

Molecular dynamics simulation of Sc2O3-Gd2O3-Y2O3 dopant effect on the crystal structure and thermophysical properties of zirconia-based ceramic materials

Effect of CeO2 doping on high temperature oxidation resistance of YSZ TBCs

Effect of thermal treatment at high temperature on phase stability and transformation of Yb2O3 and Y2O3 co-doped ZrO2 ceramics

Influence of Gd2O3 and Yb2O3 Co-doping on Phase Stability, Thermo-physical Properties and Sintering of 8YSZ

Preparation and High-Temperature Performance of Sc2O3-Y2O3 Co-Stabilized ZrO2 Thermal Barrier Coatings

Thermophysical and mechanical properties of cubic, tetragonal and monoclinic ZrO2

Thermophysical Properties of Multiple Rare Earth Oxide Co-Doped Zirconia-Based Ceramic Materials

Fabrication and Characterization of CeO2-Doped Yttria-Stabilized ZrO2 Composite Particles

Improvement on the Phase Stability, Mechanical Properties and Thermal Insulation of Y2O3-stabilized ZrO2 by Gd2O3 and Yb2O3 Co-Doping

Phase stability and thermal conductivity of ytterbia and yttria co-doped zirconia

Tailoring the thermal conductivity of Sc2O3–Yb2O3 Co-stabilized ZrO2 thermal barrier materials and mechanism insight

Thermo-physical and mechanical properties of Yb2O3 and Sc2O3 co-doped Gd2Zr2O7 ceramics