Abstract:6-8 wt% yttria-stabilized zirconia (YSZ) has been widely employed as thermal barrier coating (TBC) to protect the high-temperature components of aero-engine and gas-turbine. However, the phase transition and sintering densification at high temperature seriously limit its application above 1200 °C. On account of this, CeO2 and Sc2O3 were doped into the YSZ by solid-state reaction sintering method in this paper. The effects of doping on the crystal structure, phase transition behavior and sintering resistance were investigated on the basis of XRD, Raman and FESEM, and the evolution of thermal properties of the ceramics was also analyzed. The results indicated that doped CeO2 increases the cell volume and tetragonal degree, but doped Sc2O3 was opposite. Co-doping caused not only significant difference in atomic mass and radius but also the formation of a large number of oxygen vacancies in the ceramics. Therefore, CeScYSZ showed the lowest thermal conductivity (1.53 W‧m−1‧K−1), which was about 23% lower than that of YSZ (2.00 W‧m−1‧K−1). More importantly, the oxygen vacancy also effectively stabilized the octet lattice, while the increase of lattice energy caused by Sc-O bond made it difficult for ions to misplace, which finally well prevented the transformation from t phase to m phase. There was no detrimental m-ZrO2 phase formation in the CeScYSZ after 120 h at 1500 °C. Besides, Co-doping could simultaneously overcome the poor sintering resistance caused by single CeO2 doping and the lower thermal expansion coefficient caused by single Sc2O3 doping, thus the CeScYSZ should be an ideal long-acting thermal protection material at higher temperatures.

Phase evolution and hot corrosion behavior of Yb2O3 and CeO2 co-doping YSZ ceramics under high temperature

Effect of doping CeO2 and Sc2O3 on structure, thermal properties and sintering resistance of YSZ

Effect of thermal treatment at high temperature on phase stability and transformation of Yb2O3 and Y2O3 co-doped ZrO2 ceramics

Hot corrosion behaviors of SrZrO3 ceramic co-doped with Y2O3 and Yb2O3 in molten Na2SO4, V2O5, and Na2SO4 + V2O5 salts mixture

Phase Composition and Stability, Sintering and Thermal Conductivity of Gd2O3 and Yb2O3 Co-Doped YSZ

Improvement on the Phase Stability, Mechanical Properties and Thermal Insulation of Y2O3-stabilized ZrO2 by Gd2O3 and Yb2O3 Co-Doping

Preparation, Thermophysical Properties, and Thermal Shock Resistance of Yb2O3-doped YSZ Coatings

Phase stability and thermal conductivity of ytterbia and yttria co-doped zirconia

Mechanical Properties Durability of Sc2O3-Y2O3 Co-Stabilized ZrO2 Thermal Barrier Materials for High Temperature Application

Investigation of Ternary Rare Earth Oxide-Doped YSZ and Its High Temperature Stability

Sc3+:Ce4+:Y3+ doped zirconia nanopowders (ScCeYSZ): Synthesis, thermal phase stability and hot corrosion behavior of spark plasma sintered body

Comparison of corrosion behaviors of Sc2O3-CeO2 co-stabilized ZrO2 and YSZ ceramics exposed to CMAS at 1250°C

Influence of Gd2O3 and Yb2O3 Co-doping on Phase Stability, Thermo-physical Properties and Sintering of 8YSZ

Influence of Y2O3 Doping on Phase Evolution and Dielectric Characteristics of ZrO2 Ceramics

Phase Stability and Thermal Conductivity of La<sub>2</sub>O<sub>3</sub>, Y<sub>2</sub>O<sub>3</sub> Stabilized ZrO<sub>2</sub> Ceramic for Thermal Barrier Coating Application

Influence of various additions of Ti4+ substitution Ce4+ on high-temperature phase stability of co-precipitation Ti4+and Ce4+ co-doping YSZ powders

Phase Stability and Thermal Conductivity of La<sub>2</sub>O<sub>3</sub>, Y<sub>2</sub>O<sub>3</sub> Stabilized ZrO<sub>2</sub> Ceramic for Thermal Barrier Coating Application

Investigation on the phase stability, sintering and thermal conductivity of Sc2O3–Y2O3–ZrO2 for thermal barrier coating application

Phase, compositional, structural, and chemical stability of La2Ce2O7 after high temperature heat treatment

Determinations of Ce Solid Solution Mechanism and Limit Thermal Conductivity of YTaO4 Ceramics

Thermal aging and CMAS corrosion behaviors of Y2SiO5 ceramic for environmental barrier coatings

Phase evolution and hot corrosion behavior of Yb2O3 and CeO2 co-doping YSZ ceramics under high temperature

Effect of doping CeO2 and Sc2O3 on structure, thermal properties and sintering resistance of YSZ

Effect of thermal treatment at high temperature on phase stability and transformation of Yb2O3 and Y2O3 co-doped ZrO2 ceramics

Hot corrosion behaviors of SrZrO3 ceramic co-doped with Y2O3 and Yb2O3 in molten Na2SO4, V2O5, and Na2SO4 + V2O5 salts mixture

Phase Composition and Stability, Sintering and Thermal Conductivity of Gd2O3 and Yb2O3 Co-Doped YSZ

Improvement on the Phase Stability, Mechanical Properties and Thermal Insulation of Y2O3-stabilized ZrO2 by Gd2O3 and Yb2O3 Co-Doping

Preparation, Thermophysical Properties, and Thermal Shock Resistance of Yb2O3-doped YSZ Coatings

Phase stability and thermal conductivity of ytterbia and yttria co-doped zirconia

Mechanical Properties Durability of Sc2O3-Y2O3 Co-Stabilized ZrO2 Thermal Barrier Materials for High Temperature Application

Investigation of Ternary Rare Earth Oxide-Doped YSZ and Its High Temperature Stability

Sc3+:Ce4+:Y3+ doped zirconia nanopowders (ScCeYSZ): Synthesis, thermal phase stability and hot corrosion behavior of spark plasma sintered body

Comparison of corrosion behaviors of Sc2O3-CeO2 co-stabilized ZrO2 and YSZ ceramics exposed to CMAS at 1250°C

Influence of Gd2O3 and Yb2O3 Co-doping on Phase Stability, Thermo-physical Properties and Sintering of 8YSZ

Influence of Y2O3 Doping on Phase Evolution and Dielectric Characteristics of ZrO2 Ceramics

Phase Stability and Thermal Conductivity of La&lt;sub&gt;2&lt;/sub&gt;O&lt;sub&gt;3&lt;/sub&gt;, Y&lt;sub&gt;2&lt;/sub&gt;O&lt;sub&gt;3&lt;/sub&gt; Stabilized ZrO&lt;sub&gt;2&lt;/sub&gt; Ceramic for Thermal Barrier Coating Application

Influence of various additions of Ti4+ substitution Ce4+ on high-temperature phase stability of co-precipitation Ti4+and Ce4+ co-doping YSZ powders

Phase Stability and Thermal Conductivity of La<sub>2</sub>O<sub>3</sub>, Y<sub>2</sub>O<sub>3</sub> Stabilized ZrO<sub>2</sub> Ceramic for Thermal Barrier Coating Application

Investigation on the phase stability, sintering and thermal conductivity of Sc2O3–Y2O3–ZrO2 for thermal barrier coating application

Phase, compositional, structural, and chemical stability of La2Ce2O7 after high temperature heat treatment

Determinations of Ce Solid Solution Mechanism and Limit Thermal Conductivity of YTaO4 Ceramics

Thermal aging and CMAS corrosion behaviors of Y2SiO5 ceramic for environmental barrier coatings

Phase Stability and Thermal Conductivity of La<sub>2</sub>O<sub>3</sub>, Y<sub>2</sub>O<sub>3</sub> Stabilized ZrO<sub>2</sub> Ceramic for Thermal Barrier Coating Application