Abstract:The highly reactive chemical nature of aluminum makes it production energy-intensive or essentially impossible to extract alloying elements from Al-based liquids. Using molten salt fluxing and electrolysis processes can effectively refine coarse Al scraps. However, the generation of toxic gases and hazardous dross during these processes can cause significant environmental protection challenges and result in notable social concerns. Therefore, the primary recycling of post-consumer Al in industries currently proceeds mainly in a cascade manner, which is not sustainable when considering the Al cycle trends in the coming decades. Herein, we develop a novel process to separate primary Al from the crystallizing liquid when a constant electromagnetic force (EMF) is applied. Using this technique, we successfully upgraded Al–7mass%Si (hereafter, unless specified otherwise) alloy to approximately Al–3.6%Si in directional solidification. The separation mechanism was discussed in terms of the electrical properties of the respective phases during solidification. Fluid flow simulation results were applied to elucidate the separation behavior in the alloy. The upper and lower limits to separate the crystallizing alloy into an Al-rich and Si-rich areas were determined when the controlling factors were clarified, which made it possible to scale up the present laboratory-based setup to an industrial level. Moreover, the energy consumption of the process was slightly higher than that required for remelting only. Using the EMF technique to separate the crystallizing alloy into Al-rich and Si-rich regions did not produce hazardous dross or toxic gases. This energy-saving and eco-friendly process can provide a breakthrough to overcome the "dead metal" crisis and thus realize sustainability by upgrading recycling of post-consumer hypoeutectic Al–Si casting alloys.

Enhancing Segregation Behavior of Impurity by Electromagnetic Stirring in the Solidification Process of Al-30Si Alloy

Controlling Segregation Behavior of Primary Si in Hypereutectic Al-Si Alloy by Electromagnetic Stirring

Effects of AlB2/AlP Phase and Electromagnetic Stirring on Impurity B/P Removal in the Solidification Process of Al-30Si Alloy

Separation Mechanism of the Primary Si Phase from the Hypereutectic Al–Si Alloy Using a Rotating Magnetic Field During Solidification

Separation and Purification of Si from Solidification of Hypereutectic Al–Si Melt under Rotating Magnetic Field

An Efficient Method to Purify Metallurgical Grade Si by Electromagnetic Semi-Continuous Casting of Al-30Si Melt

Effect of Sn Addition on the Separation and Purification of Primary Si from Solidification of Al-30Si Melt under Electromagnetic Stirring

Segregation Behavior of Iron in Metallurgical Grade Silicon During Si-Cu Solvent Refining

Effect of Traveling Magnetic Field on Separation and Purification of Si from Al–Si Melt During Solidification

Si Purity Control and Separation from Solidification of Al–30Si Melt under Pulse Electromagnetic Field

Separation of Primary Si and Impurity Boron Removal from Al-30%Si-10%Sn Melt under a Traveling Magnetic Field

Separation and Purification of Si from Sn-30Si Alloy by Electromagnetic Semi-Continuous Directional Solidification

Effect of Si Content on Separation and Purification of the Primary Si Phase from Hypereutectic Al–Si Alloy Using Rotating Magnetic Field

Control of silicon solidification and the impurities from an Al-Si melt

Super-gravity field assisted homogeneous distribution of sub-micron eutectic Si in Al-Si alloy

Si Purification by Removal of Entrapped Al During Electromagnetic Solidification Refining of Si-Al Alloy

Enhancing the separation of Fe/Al/Ca impurities from metallurgical silicon to purify by slagging-directional solidification

Crystal Growth Mechanism of Si in Hypereutectic Al-Si Melt During the Electromagnetic Directional Solidification

Transport Mechanism of Fe Impurity During the Purification of Silicon by Electromagnetic Directional Solidification of Hypereutectic Si–Ti Melt

Effect of electromagnetic stirring on the enrichment of primary silicon from Al–Si melt

Upgrading recycling of Al–7 wt%Si alloys using electromagnetic force in directional solidification