Abstract:Numerical simulations of the cutting process play a key role in manufacturing and cost optimization. Inherent in finite element analysis (FEA) simulations is the correct description of material behavior during machining. For this purpose, various material models are used to describe the behavior of the material in the range of high deformation, high temperature values, and high strain rates. Very often the Johnson–Cook (JC) material model is used for this purpose; however, the correct determination of the material constants of this model is a key aspect. Therefore, this paper presents a procedure for determining the material constants of the JC model using an analytical method based on normalized tensile and compression testing of the material for different strain rates over a wide temperature range. After determining the material constants, the authors conducted numerical simulations of the orthogonal turning of Ti6Al4V titanium alloy using the obtained constants. Validation of the obtained results with those obtained in experimental studies was also carried out. The outcomes demonstrated that the difference between FEM simulation and experimental tests did not exceed 0.02 mm (14%) in the case of chip thickness,. Much smaller differences were obtained for the temperature in the cutting zone, where the maximum difference was about 45 °C (4%). Comparing the components of the cutting force, we found that, in the case of the main cutting force, in most cases, the differences did not exceed 70 N (8%). After the verification of the obtained results, it was also found that the determined material constants of the Johnson–Cook model can be successfully used in FEM modeling of the cutting process of Ti6Al4V titanium alloy for the adopted range of values of technological parameters.

An Improved Johnson-Cook Constitutive Model And Its Experiment Validation On Cutting Force Of Adc12 Aluminum Alloy During High-Speed Milling

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Constitutive Model of Aviation Aluminum-Alloy Material in Metal Machining

Optimization of Milling Aluminum Alloy 6061-T6 using Modified Johnson-Cook Model

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Experimental Studies of Cutting Temperature During High-Speed Milling of Aerospace Aluminum

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

Research on Conventional and High-Speed Machining Cutting Force of 7075-T6 Aluminum Alloy Based on Finite Element Modeling and Simulation

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models

An improved material constitutive model for simulation of high-speed cutting of 6061-T6 aluminum alloy with high accuracy

Constitutive Model of Physical Simulation in High Speed Cutting for Al6061-T6

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

Inverse determination of improved constitutive equation for cutting titanium alloy Ti-6Al-4V based on finite element analysis

Constitutive Model of 2cr13 for Finite Element Analysis of Chip Formation Process

A Hybrid Cutting Force Model for High-speed Milling of Titanium Alloys

Finite element simulations of Ti6Al4V titanium alloy machining to assess material model parameters of the Johnson-Cook constitutive equation

A modified parallel-sided shear zone model for determining material constitutive law