Abstract:The solid electrolyte Li0.5La0.5TiO3 is widely used in solid-state batteries due to its high grain conductivity at room temperature (RT). Researchers have often improved its huge grain boundary impedance by optimizing its crystal structure and doping it with suitable elements. Here, an Li0.5−y+xSrxLa0.5−xTi1−yNbyO3(LLSTN, x = 0, 0.04, 0.06, 0.08, and 0.1 mol%) ceramic solid electrolyte was prepared via the conventional solid-state reaction method. The introduction of Sr2+ and Nb5+ increases the lithium-ion content and transforms the Li3xLa2/3−xTiO3 (LLTO) crystal structure from tetragonal to cubic. The resultant LLSTN samples have a high conductivity and are characterized by the coexistence of the two phases. On the other hand, the lattice constant becomes larger, causing the migration channel of the lithium ions to become larger. At the same time, the introduction of Nb5+ increases the concentration of lithium vacancies, which facilitates the transport of the lithium ions. With increasing doping amount, lithium lanthanum niobate is formed between the the crystals grains, which inhibits grain growth. The presence of lithium lanthanum niobate, which is an ionic conductor, at the grain boundaries, effectively decreases the LLTO grain boundary impedance. The conductivity of sample Li0.5La0.42Sr0.08Ti0.92Nb0.08O3 reaches 5.10×10−5S·cm−1 at RT, which is about six times higher than that of the undoped sample, and the activation energy is 0.28 eV.

Study on the electrical conductivity of In-doped SrTiO3 with B-site deficiency prepared by sol-gel method

Effect of B-site Deficiency on the (in, Fe) Co-Doped SrTiO 3

Microstructure and electrical conductivity of A-site fully stoichiometric Na0.5+xBi0.5−xTiO3−δ with different Na/Bi ratios

Influence of Sr2+ ion content on the structural and electrical properties of Ba1-xSrxTiO3 nanopowders

Defect Dipoles Induced High‐energy Storage Density in Mn‐doped BST Ceramics Prepared by Spark Plasma Sintering

Evaluation of A-site deficient Sr1−xSc0.175Nb0.025Co0.8O3−δ (x=0, 0.02, 0.05 and 0.1) perovskite cathodes for intermediate-temperature solid oxide fuel cells

Sol–gel Synthesis and Characterization of Ba(1−x)SrxTiO3 Ceramics

Preparation and conductivity of Sr1-xBixFeO3-delta(x <= 0.5) by citrate methods

Preparation and Electric Properties of La-Doped-(Sr,Ba)Tio3 from Sol-Gel Process

Investigation of the structural and electrical properties of Sr1−xBi2.2Ta2O9 thin films with deficient Sr contents

Synthesis and characterization of Pr0.6-xNdxSr0.4FeO3-delta system compounds

The Influence of Mn Doping on the Dielectric Properties of Ba0.5Sr0.5TiO3 Ceramics

A-site-deficiency range identified for in situ exsolution from (La0.4Sr0.6)1- αTi0.95Ni0.05O3± δ electrodes for SOFC and SOEC

Influence of A-site nonstoichiometry on sintering, microstructure and electrical properties of (Bi0.5Na0.5)TiO3 ceramics

Structure and Conductivity of Perovskites Sr1−xLaxTi1−xCrxO3

Characterization and Electrical Properties of Sol-Gel Synthesized (sr, Pb)TiO3 Powders

Preparation and Conductivity of Sr1-xBixFeO3-δ(x0.5) by Citrate Methods

Synthesis and thermoelectric properties of nd-doped uddlesden-popper phase SrO(SrTiO3)n (n=1,2) oxides

Sodium Deficiency in Na0.5bi0.5tio3

Synthesis and Electrical Properties of Co-doped Y0.08Sr0.92TiO3 − Δ As a Potential SOFC Anode

Effect of Sr and Nb co-doped on the total conductivity of Li0.5La0.5TiO3 ceramic electrolytes