Abstract:The printed circuit heat exchanger (PCHE) is extensively used in several applications due to exceptional compactness and heat transfer efficiency. However, the dominant failure mode of PCHE is creep fracture in its diffusion welding joints. Therefore, an accurate prediction of the creep crack propagation behavior for diffusion welding joints is essential for assessing the life of PCHE. In this paper, based on the research route from material to structure, the creep properties of 316L stainless steel base metal and its diffusion welding joint are firstly measured. On this basis, a constitutive model incorporating a time-hardening term for describing the creep damage is established. Furthermore, the creep damage and service life of the PCHE structure under working conditions (600 °C, 20 MPa) are analyzed, along with the effects of structure factors on the creep crack propagation behavior. The results show that the initial decelerating stage and the steady state stage play a dominate role in the creep curve of the diffusion welding joint, differing from the base metal's creep curve. Besides, the creep rate of the joint is approximately 30 times that of the base metal. The established creep damage constitutive model effectively characterizes the creep crack propagation behavior of diffusion welding joints. The maximum creep strain occurs at the weld metal and continuous operation for 100,000 h can be achieved at the designed working condition (600 °C, 20 MPa). For the purpose of lifetime extension by restraining the creep crack, it is recommended to increase the spacing and fillet radius while reducing the diameter during design process.

Creep of plate-fin structures in compact heat exchangers

Creep of Brazed Plate-Fin Structures in High Temperature Compact Heat Exchangers

Study on Reliability of High Temperature Heat Exchangers

Creep-fatigue strength design of plate-fin heat exchanger by a homogeneous method

Creep damage and crack propagation behavior of printed circuit heat exchanger manufactured by diffusion welding: from material to structure

The Effect of Filler Metal Thickness on Residual Stress and Creep for Stainless-Steel Plate–fin Structure

3-D finite element analysis of residual stress and its creep relaxation at high temperature for stainless steel brazed plate-fin structure

Viscoelastic Model to Describe Mechanical Response of Compact Heat Exchangers with Plate-Foam Structure

Finite Element Analysis of Creep of Stainless Steel Plate-Fin Structure

Three-dimensional Numerical Simulation of Brazed Residual Stress and Its High-Temperature Redistribution for Stainless Steel Plate-Fin Structure

Strength design and life assessment of welded structures subjected to high temperature creep

Some Critical Issues in Creep and Fracture Assessment at High Temperature

Finite Element Analysis of the Effect of Brazed Residual Stress on Creep for Stainless Steel Plate-Fin Structure

Effect of Brazing Residual Stress on Creep for Stainless Steel Plate-Fin Structure

Creep-fatigue Endurance of a Superheater Tube Plate under Non-Isothermal Loading and Multi-Dwell Condition

Effect of Filler Metal Thickness on Creep for Stainless Steel Plate-Fin Structure

Viscoelastic Analysis of Rectangular Passage of Microchanneled Plates Subjected to Internal Pressure

Evaluation of creep damage of the steam pipelines with high temperature and high pressure

High Temperature Creep Strength of As-cast Ni-based Brazing Filler

Steady-state and Dynamic Performance of High Temperature Compact Plate-Fin Heat Exchanger

Multiaxial Creep Strength Design for High Temperature Components in Coal-Fired Power Plants