Abstract:The printed circuit heat exchanger (PCHE) is extensively used in several applications due to exceptional compactness and heat transfer efficiency. However, the dominant failure mode of PCHE is creep fracture in its diffusion welding joints. Therefore, an accurate prediction of the creep crack propagation behavior for diffusion welding joints is essential for assessing the life of PCHE. In this paper, based on the research route from material to structure, the creep properties of 316L stainless steel base metal and its diffusion welding joint are firstly measured. On this basis, a constitutive model incorporating a time-hardening term for describing the creep damage is established. Furthermore, the creep damage and service life of the PCHE structure under working conditions (600 °C, 20 MPa) are analyzed, along with the effects of structure factors on the creep crack propagation behavior. The results show that the initial decelerating stage and the steady state stage play a dominate role in the creep curve of the diffusion welding joint, differing from the base metal's creep curve. Besides, the creep rate of the joint is approximately 30 times that of the base metal. The established creep damage constitutive model effectively characterizes the creep crack propagation behavior of diffusion welding joints. The maximum creep strain occurs at the weld metal and continuous operation for 100,000 h can be achieved at the designed working condition (600 °C, 20 MPa). For the purpose of lifetime extension by restraining the creep crack, it is recommended to increase the spacing and fillet radius while reducing the diameter during design process.

Creep of Brazed Plate-Fin Structures in High Temperature Compact Heat Exchangers

Creep of plate-fin structures in compact heat exchangers

3-D finite element analysis of residual stress and its creep relaxation at high temperature for stainless steel brazed plate-fin structure

Study on Reliability of High Temperature Heat Exchangers

Three-dimensional Numerical Simulation of Brazed Residual Stress and Its High-Temperature Redistribution for Stainless Steel Plate-Fin Structure

The Effect of Filler Metal Thickness on Residual Stress and Creep for Stainless-Steel Plate–fin Structure

Creep damage and crack propagation behavior of printed circuit heat exchanger manufactured by diffusion welding: from material to structure

Some Critical Issues in Creep and Fracture Assessment at High Temperature

Strength design and life assessment of welded structures subjected to high temperature creep

Finite Element Analysis of the Effect of Brazed Residual Stress on Creep for Stainless Steel Plate-Fin Structure

Creep-fatigue strength design of plate-fin heat exchanger by a homogeneous method

Finite Element Analysis of Creep of Stainless Steel Plate-Fin Structure

High Temperature Creep Strength of As-cast Ni-based Brazing Filler

Effect of Brazing Residual Stress on Creep for Stainless Steel Plate-Fin Structure

Experimental Research and Numerical Simulation on Creep Behavior of Brazed Joint at High Temperature

Creep-fatigue Endurance of a Superheater Tube Plate under Non-Isothermal Loading and Multi-Dwell Condition

Multiaxial Creep Strength Design for High Temperature Components in Coal-Fired Power Plants

Evaluation of creep damage of the steam pipelines with high temperature and high pressure

Some Fundamental Aspects of High Temperature Defect Assessment

Effect of Filler Metal Thickness on Creep for Stainless Steel Plate-Fin Structure

Creep Behavior and Cavitation Evolution of 15crmog Steel at High Temperatures