Abstract:Compact heat exchangers such as tube-fin types and plate-fin types are widely used for gas-liquid or gas-gas applications. Some examples are air-coolers, fan coils, regenerators and recuperators in micro-turbines. In this study, thermal design of fin-and-tube (tube-fin) heat exchanger performance with fins being employed outside and inside tubes was presented, with which designed plate-fin heat exchanger was compared. These designs were performed under identical mass flow rate, inlet temperature and operating pressure on each side for recuperator in 100kW microturbine as well as specified allowable fractions of total pressure drop by means of Log-Mean Temperature Difference (LMTD) method. Heat transfer areas, volumes and weights of designed heat exchangers were evaluated. It is shown that, under identical heat duty, fin-and-tube heat exchanger requires 1.8 times larger heat transfer area outside tubes and volume, 0.6 times smaller heat transfer area inside tubes than plate-fin heat exchanger. Under identical total pressure drop, fin-and-tube heat exchanger requires about 5 times larger volume and heat transfer area in gas-side, 1.6 times larger heat transfer area in air-side than plate-fin heat exchanger. Total weight of fin-and-tube heat exchanger is about 2.7 times higher than plate-fin heat exchanger, however, the heat transfer rate of fin-and-tube heat exchanger is about 1.4 times larger than that of plate-fin heat exchanger. It is indicated that, both-sides finned tube heat exchanger may be used in engineering application where the total pressure drop is severe to a small fraction and the operating pressure is high, and may be adopted for recuperator in microturbine.

Study on Reliability of High Temperature Heat Exchangers

Compact Metallic High-Temperature Heat Exchangers

Creep of plate-fin structures in compact heat exchangers

Stress Study on Different Designs of Ceramic High Temperature Heat Exchangers

Creep of Brazed Plate-Fin Structures in High Temperature Compact Heat Exchangers

Stress analysis of internally finned bayonet tube in a high temperature heat exchanger

Study on Local Thermal–hydraulic Performance and Optimization of Zigzag-Type Printed Circuit Heat Exchanger at High Temperature

Experimental Investigation on Heat Transfer and Pressure Drop in a Microtubine Recuperator with Cross-Wavy Primary Surface Channels

Investigation of a Novel High Temperature Heat Exchanger with Hybrid Internally and Externally Finned Tubes

Numerical Research on High Temperature Stress Characteristic of Internally Finned Bayonet Tube

Finite Element Analysis of Stress on Cross-Wavy Primary Surface Recuperator Based on Thermal-Structural Coupling Model

Analytical and Numerical Study on the Uniformity of Temperature Difference Field in Heat Exchangers

Thermal Design of a Shell and Tube Heat Exchanger with Internal Fins

Experimental Investigation on Heat Transfer Characteristics of High Temperature Air in Round Tube

Numerical and experimental investigations of the heat transfer and fatigue life of a new W-type mini microchannel heat exchanger

Investigation of a Novel Bayonet Tube High Temperature Heat Exchanger with Inner and Outer Fins

Experimental Study on the Tube-Side Thermal-Hydraulic Performance of Spiral Wound Heat Exchangers

Three-Dimensional Stress Analysis And Configuration Optimization Of Cross Wavy Primary Surface Recuperator For Microturbine System

Thermal Design Of Heat Exchanger With Fins Inside And Outside Tubes

Creep Analysis Of Cross Wavy Primary Surface Recuperator For Microturbine System

The single-blow transient test technique using pulse change inlet condition with optimized pulse width and matching time