Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Comprehensive Comparison of the Applicability of Internally Ribbed and Microfin Tubes for TORC Systems

Heat Transfer Investigation of Supercritical R134a for Trans-Critical Organic Rankine Cycle System

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Numerical study of supercritical-pressure fluid flows and heat transfer of methane in ribbed cooling tubes

Numerical Study of Thermal-Hydraulic Performance Improvement of Enhanced Surface Tubes

Experimental Study on Heat Transfer to the Supercritical Water Upward Flow in a Vertical Tube with Internal Helical Ribs

Experimental Study of Buoyancy Effect and Its Criteria for Heat Transfer of Supercritical R134a in Horizontal Tubes

Numerical analysis of buoyancy effect and heat transfer enhancement in flow of supercritical water through internally ribbed tubes

Comprehensive evaluation on the thermal-hydraulic performance of supercritical CO2/R41 in a micro-fin tube

Experimental Investigation on Convective Heat Transfer of Hydrocarbon Fuel in Transverse Corrugated Tubes

Supercritical CO 2 flow and heat transfer through tapered horizontal mini-tubes: Parametric analysis and optimization study

Experimental Investigation of the Heat Transfer of Supercritical R134a in a Horizontal Micro-Fin Tube

Heat Transfer of R134a in a Horizontal Internally Ribbed Tube and in a Smooth Tube under Super Critical Pressure

Experimental Research on the Flow and Heat Transfer Characteristics of Subcritical and Supercritical Water in the Vertical Upward Smooth and Rifled Tubes

Experimental study on single-phase heat transfer performance of internal helically finned tubes covering low Reynolds number in turbulent flow

Turbulent flow and heat transfer in a new type of internally torsion-ribbed helical tube

A Brief Review on Convection Heat Transfer of Fluids at Supercritical Pressures in Tubes and the Recent Progress

Improved Gas Heaters for Supercritical CO2 Rankine Cycles: Considerations on Forced and Mixed Convection Heat Transfer Enhancement

Comparison of flow boiling heat transfer characteristics inside different enhanced heat transfer tubes

Comparison Between Heat Transfer to Supercritical Water in A Smooth Tube and in an Internally Ribbed Tube