Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Comparison of flow boiling heat transfer characteristics inside different enhanced heat transfer tubes

Flow Boiling Heat Transfer Characteristics in Horizontal, Three-Dimensional Enhanced Tubes

Flow Boiling in Inner Annulus of Horizontal Enhanced Tubes

Experimental Investigation of Flow Boiling Inside Three Three-Dimensional Surface Enhanced Heat Transfer Tubes

Experimental Study Of Condensation Flow Inside Horizontal Smooth, Herringbone And Three Enhanced Surface Tubes

An Experimental Study on Flow Boiling Heat Transfer Outside Horizontal Enhanced Tubes

Experimental study on the flow boiling heat transfer in horizontal tubes with composite structure

Experimental Study on Heat Transfer Performance and Flow Pattern in Micro-Fin Tubes and 1EHT Three-Dimensional Heat Exchange Tubes

Eexperimental Study On Flow Evaporation Heat Transfer Characteristics Inside Horizontal Three-Dimensional Enhanced Tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental Study of Boiling Heat Transfer in Smooth/micro-Fin Tubes of Four Refrigerants

Evaporation Heat Transfer Characteristics of R410A Inside Horizontal Three-Dimensional Enhanced Tubes

Heat Transfer Performance of Microfin Tubes and -Three-dimensional Heat Transfer Tubes

Condensation Characteristics of Flows in Newly Developed, Three-Dimensional Enhanced Heat Transfer Tubes

Experimental Study on Condensation and Evaporation Flow Inside Horizontal Three Dimensional Enhanced Tubes

Flow Boiling in Horizontal Annuli Outside Horizontal Smooth, Herringbone and Three-Dimensional Enhanced Tubes

EXPERIMENTAL STUDY ON HEAT FLUX EFFECT ON EVAPORATION IN TWO DIMPLE-GROOVED TUBES

Condensation Heat Transfer Experiments of R410A and R32 in Horizontal Smooth and Enhanced Tubes

Forced Convection Heat Transfer Outside Enhanced Tubes with Different Surface Structures

Flow Boiling Characteristics Of R410a In Horizontal Annuli Of Enhanced Surface Tubes

Experimental Study on Heat Transfer Characteristics of R134a Flow Boiling in “Ω”-Shaped Grooved Tube with Different Flow Directions