Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Discrete Element Simulation of Micro-Particle Deposition on a Cylindrical Fiber in an Array

The Influence of Particle-Size Distribution on Critical State Behavior of Spherical and Non-Spherical Particle Assemblies

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Electrically-enhanced Deposition of Fine Particles on a Fiber: A Numerical Study Using DEM

Mechanistic Studies of Initial Deposition of Fine Adhesive Particles on a Fiber Using Discrete-Element Methods

Adhesive Particulate Flow: the Discrete-Element Method and Its Application in Energy and Environmental Engineering

Investigation of Dynamic Behaviour of a Particle-loaded Single Fibre Using Discrete Element Methods

A Bonded Sphero-Cylinder Model for the Discrete Element Simulation of Elasto-Plastic Fibers

CFD-DEM Coupling Model for Deposition Process Analysis of Ultrafine Particles in a Micro Impinging Flow Field

Packing of Cylindrical Particles: DEM Simulations and Experimental Measurements

A spheropolyhedral-based discrete element lattice Boltzmann method for simulation of non-spherical adhesive particulate flow

Discrete Element Method Simulation of Particulate Material Fracture Behavior on a Stretchable Single Filter Fiber with Additional Gas Flow

A new discrete element method for small adhesive non-spherical particles

Numerical Simulation of the Accumulation of Heavy Particles in a Circular Bounded Vortex Flow

Discrete Element Method Simulations for Complex Granular Flows

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

A fast adhesive discrete element method for random packings of fine particles

Numerical Simulation of Particle Sedimentation in Shear-Thinning Fluids with a Fictitious Domain Method

Filtration of Micro-Particles Within Multi-Fiber Arrays by Adhesive DEM-CFD Simulation

Discrete Element Simulations of Flexible Ribbon-Like Particles

Direct Numerical Simulation of Multiple Particles Sedimentation at an Intermediate Reynolds Number