Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Investigation of Dynamic Behaviour of a Particle-loaded Single Fibre Using Discrete Element Methods

Sliding Behaviour of Carbon Nanothread Within a Bundle Embedded in Polymer Matrix

Discrete Element Simulation of Micro-Particle Deposition on a Cylindrical Fiber in an Array

Electropolymerization of pyrrole on PAN-based carbon fibers: experimental observations and a multiscale modeling approach

Mechanistic Studies of Initial Deposition of Fine Adhesive Particles on a Fiber Using Discrete-Element Methods

Experimental investigation on the particle capture by a single fiber using microscopic image technique

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Electrically-enhanced Deposition of Fine Particles on a Fiber: A Numerical Study Using DEM

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

Discrete Element Method Models of Elastic and Elastoplastic Fiber Assemblies

Multiscale Simulation of the Responses of Discrete Nanostructures to Extreme Loading Conditions Based on the Material Point Method

Research on Piezoresistive Effect and Random Model of Carbon Fiber Bundle

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Nonlinear force dependence on optically bound micro-particle arrays in the eva-nescent fields of fundamental and higher order microfibre modes

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

Investigation of the interactions between two contact fibers in the fiber suspensions

Rate-dependent adhesion in dynamic contact of spherical-tip fibrillar structures

A many-body dissipative particle dynamics study of eccentric droplets impacting inclined fiber

Caustic Investigation of Dynamic Interactions Between Propagating Matrix Crack and Modified Fibre Bundles

Micro-CT Based Meso-Scale Modeling and Peridynamics Analysis for Short-Fiber Composites

Growth and Morphosis of Particle Chains During Fly Ash Loading on a Single Fiber