Abstract:This paper presents an experimental investigation and a finite element (FE) analysis study on the thermal and mechanical behaviors of insulated-gate bipolar transistor (IGBT) power modules under various operating conditions. The power cycling test conditions are provided by two test benches, a direct current (DC) test bench and a pulse width modulation (PWM) test bench. Infrared (IR) camera acquisition methods are suggested as an approach for transient temperature measurements to estimate the effects of operating conditions and switching frequency on the thermal performance of an IGBT module. An electrical–thermal–mechanical FE model of an IGBT module is employed to determine the stress in the interconnections of an IGBT module induced by junction temperature fluctuations. Results indicate that the operating conditions significantly impact the maximum junction temperature, the junction temperature increase rate, and the junction temperature distribution of an IGBT chip and the thermally induced stress in the interconnections. The switching frequency strongly impacts the junction temperature of an IGBT chip, and the maximum junction temperature increases when the switching frequency increases due to the increasing switching loss. Furthermore, the junction temperature variation induced by the instantaneous switching loss is estimated by the proposed IR camera measurement method.

Condition Monitoring of IGBT Module and Forced Air Cooling System Using Time Constants of Heat Sink Temperature Cooling Curve

Condition Monitoring Igbt Module Bond Wires Fatigue Using Short-Circuit Current Identification

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

Thermal-Fluid Co-Simulation and Modelling of IGBT with Thermal Resistance Network

Monitoring Bond Wires Fatigue of Multichip IGBT Module Using Time Duration of the Gate Charge

A review of the cooling methods based on IGBT module and the application of micro-channel cooling in IGBT Chinese Full Text

A real-time aging monitoring method of parallel-connected IGBT modules

An Online Monitoring Method for Bond Wire Fatigue in IGBT Module

In Situ Diagnosis for IGBT Chip Failure in Multichip IGBT Modules Based on a Newly Defined Characteristic Parameter Low-Sensitive to Operation Conditions

A Transient 3-D Thermal Modeling Method for IGBT Modules Considering Uneven Power Losses and Cooling Conditions

Study of Accelerated Power Cycling Test of IGBT Power Modules

Non-Contact Degradation Evaluation for IGBT Modules Using Eddy Current Pulsed Thermography Approach

A Junction Temperature Monitoring Method for IGBT Modules Based on Turn-Off Voltage with Convolutional Neural Networks

Overview of recent progress in condition monitoring for insulated gate bipolar transistor modules: Detection, estimation, and prediction

Dynamic junction temperature estimation via built-in negative thermal coefficient (NTC) thermistor in high power IGBT modules

In-situ Monitoring Chip Failure in Multichip IGBT Modules Using Turn-on Delay Time Extracted from Auxiliary Emitter Voltage

Chip Metallization Aging Monitoring with Induced Voltage Vee Between Kelvin and Power Emitter for High Power IGBT Modules

LF-OCT Based Non Destructive Testing for IGBT Module

A Fast IGBT Junction Temperature Estimation Approach Based on ON-State Voltage Drop

Comparison of junction temperature variations of IGBT modules under DC and PWM power cycling test conditions

3D Thermal Resistance Model for Real-Time Temperature Monitoring of Multi-Chip IGBT Modules