Abstract:The use of fabric materials for inflated membrane structures has attracted considerable attention in recent decades due to light weight, high strength-to-weight ratio and excellent environmental stability. The load curtain of the catenary system for stratospheric membrane structures is a typical three-dimensional component with complex stress state, meaning that existing uniaxial and biaxial machines are not suitable to identify essential mechanical properties of this component. This paper focuses on the development of a new triaxial tensile machine and evaluation of mechanical properties of a three-dimensional load curtain component. The triaxial tensile machine with specific configurations could independently control five loads (X+/X-, Y +/Y- and Z). A series of cyclic experiments are carried out in terms of in-plane and out-of-plane angle combination. It is found that experimental observations in the first cycle and subsequent cycles are distinctly different for three-dimensional membrane components. The force reduction in the first cycle is caused by plastic deformation during loading-unloading process. The stress state in subsequent cycles is approximately elastic due to the elimination of plastic deformation in the first cycle, indicating that cyclic experiments are suitable for identifying stable mechanical properties. The force differences between X+ and X- directions are related to stiffness difference between warp and weft directions. Moreover, the effects of Z force could result in asymmetrical X and Y forces, especially for small out-of-plane angle. Furthermore, a numerical model is developed for comparing with experimental results. The X and Y forces in terms of loading and unloading are in good agreement with experimental results, which could justify numerical methods.

Modal Identification Experimental Investigations and Calculation Method for Biaxial Tensioned Membranes

Combined Method for Quick Analysis of Tensile Membrane Structures

ENERGY-MOMENTUM BASED APPROACH FOR DEPLOYMENT ANALYSIS OF SPACE MEMBRANE STRUCTURES

Performance and Measurement Devices for Membrane Buildings in Civil Engineering: A Review

Design and Analysis of Inner and Outer Cables Suspended Membrane Structures

Modal Equivalent Method of Full-Area Membrane and Grid Membrane

Experimental Investigation on the Added Mass of Membranes Vibrating in Air

Dynamic Equivalent Methodology of a Rectangular Membrane and a Grid Membrane: Formulation, Simulation and Experiment

Modal behaviors and influencing factors analysis of inflated membrane structures

A Triaxial Tensile Machine for Three-Dimensional Membrane Components: Experimental Investigations and Numerical Simulations

A Non-Contact Method for Estimating the Pre-Tension of a Rectangular Membrane Structure

Modal Analysis and Identification of Deployable Membrane Structures

Effects of Air on Modal Behavior of Pre-Stressed Membrane Structure

New Progress in Dynamic Measurement of Space Based Membrane Structure

Simulation Analysis of Vibration Characteristics of Wrinkled Membrane Space Structure

The Added Mass of a Biaxial Tensioned Membrane in Still Air

Numerical Simulation Of Wind Pressure And Wind-Induced Vibration Of Tension Membrane Structure

Numerical and Experimental Studies on the Dynamic Equivalence of a Large Rectangular Membrane and a Grid Membrane

Numerical and Experimental Study on the Dynamic Equivalent Methodology of a Membrane Antenna Structure and a Grid Membrane Structure

The modal analysis and modal behavior investigations on the wrinkled membrane inflated beam

Modal Analysis of Inflated Membrane Cone Considering Pressure Follower Force Effect