Abstract:The use of fabric materials for inflated membrane structures has attracted considerable attention in recent decades due to light weight, high strength-to-weight ratio and excellent environmental stability. The load curtain of the catenary system for stratospheric membrane structures is a typical three-dimensional component with complex stress state, meaning that existing uniaxial and biaxial machines are not suitable to identify essential mechanical properties of this component. This paper focuses on the development of a new triaxial tensile machine and evaluation of mechanical properties of a three-dimensional load curtain component. The triaxial tensile machine with specific configurations could independently control five loads (X+/X-, Y +/Y- and Z). A series of cyclic experiments are carried out in terms of in-plane and out-of-plane angle combination. It is found that experimental observations in the first cycle and subsequent cycles are distinctly different for three-dimensional membrane components. The force reduction in the first cycle is caused by plastic deformation during loading-unloading process. The stress state in subsequent cycles is approximately elastic due to the elimination of plastic deformation in the first cycle, indicating that cyclic experiments are suitable for identifying stable mechanical properties. The force differences between X+ and X- directions are related to stiffness difference between warp and weft directions. Moreover, the effects of Z force could result in asymmetrical X and Y forces, especially for small out-of-plane angle. Furthermore, a numerical model is developed for comparing with experimental results. The X and Y forces in terms of loading and unloading are in good agreement with experimental results, which could justify numerical methods.

Numerical Simulation of Whole Process and States of Tensile Membrane Structure

Experimental investigation on forming design methods of ETFE cushion structure

Analysis Methods of Structural Design and Characteristics of Numerical Algorithm for ETFE Air Inflated Film Structures

Combined Method for Quick Analysis of Tensile Membrane Structures

Drape and Inflatable Mechanics of Membrane Inflatable Structure

A Triaxial Tensile Machine for Three-Dimensional Membrane Components: Experimental Investigations and Numerical Simulations

Computation Method of Zero-Stress State of Pneumatic Stressed Membrane Structure

The algorithm of zero-stress state of pneumatic stressed membrane structure

Numerical Simulation Algorithm for the Forming Process of Tensile Cable-Strut Structure

Numerical simulation of 3D angle-interlock woven fabric forming and compression processes

The Numerical Simulation of Warp Membrane Tensile Test

Numerical Studies on Buckling Process of Tensioned Plane Membrane

Finite Element Modelling for Tensile Behaviour of Thermally Bonded Nonwoven Fabric

Numerical Modeling of Wrinkling Modulation in Tensegrity-Membrane Structures

FINITE ELEMENT MODELLING OF INFLATABLE MEMBRANE STRUCTURE BASED ON PHOTOGRAMMETRY

Nonlinear Mechanical Behavior of Architectural Coated Fabric and Uncertainty Analyses for FE Model of Tensioned Membrane Structure

An Improved Semi-Discrete Approach for Simulation of 2.5D Woven Fabric Preforming

Computational methods for the zero-stress state and the pre-stress state of tensile cable-net structures

Numerical Simulation Study of the T-Peel Behavior of Coated Fabric Films Used in Inflatable Structures

Numerical Simulation Of Wind Pressure And Wind-Induced Vibration Of Tension Membrane Structure

A Refined Numerical Model for Determining Inflation-Burst Behavior of Composite Membrane Structures