Abstract:Enhanced precipitation strengthening effect and ductility of Mg-9.8Gd-3.6Y-2.2Zn-0.4Zr alloy are achieved by short-time solution treatment prior to aging, and the effects of short-time solution on microstructure differences, strengthening contribution and fracture behavior are analyzed. The IF (initial-forged state) and PA (peak-aged state) samples exhibit the similar microstructure, with numerous fragmented lamellar LPSO phase distributed within the matrix and relatively uniform small grains (∼9μm). The significant increase in grain size of SS (solid solution state) and SSPA (solid solution + peak-aged state) samples (23.1μm and 27.0μm) is related to the lack of “pinning effect” caused by the dissolution of fragmented lamellar LPSO phase, meanwhile, the fully excited static recrystallization during the solution process results in high recrystallization fraction (above 95%) for both the two samples. The σgb (grain boundary strengthening) and σss (solid solution strengthening) contribute more than 70% in both IF and SS samples, while σgb and σpp (precipitation strengthening) dominate in the PA and SSPA samples. The stronger precipitation strengthening effect and age-hardening response of SSPA sample are derived from the more and denser β' precipitates within the matrix. The deformation mechanism of PA sample is the grain boundaries sliding of fine-sized grains and the slip of blocky LPSO phase, the microcracks are mainly concentrated at the grain boundaries, the blocky LPSO phase and its interface with matrix. As a comparison, the tensile deformation mechanism of SSPA sample is sufficient intragranular slip, the microcracks are mainly concentrated at the blocky LPSO phase and extend into the matrix, and finally forming large-sized cracks and deep fracture holes, which enhances the ductility. This paper may provide new ideas for the aging process design of wrought Mg-Gd-Y-Zn-Zr alloys.

Achieving Enhanced Mechanical Properties in Mg-Gd-Y-Zn-Mn Alloy by Altering Dynamic Recrystallization Behavior Via Pre-Ageing Treatment

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Achieving ultrahigh strength in pre-ageing-extruded Mg-Gd-Y-Zn-Mn alloys via ageing treatment

Effect of Ageing Treatment on the Microstructure, Texture and Mechanical Properties of Extruded Mg–8.2Gd–3.8Y–1Zn–0.4Zr (wt%) Alloy

Preparation of ultra-high strength Mg-Gd-Y-Zn-Zr alloy by pre-ageing treatment prior to extrusion

An alternating ageing-annealing process for enhancing strength and ductility of a Mg-Gd-Y-Zn-Zr alloy

Preparation of high-performance Mg-Gd-Y-Mn-Sc alloy by heat treatment and extrusion

Effects of pre-aging on microstructure evolution and deformation mechanisms of hot extruded Mg–6Zn–1Gd–1Er Mg alloys

Effect of Pack-Forging on Microstructure and Properties of Mg-Gd-Y-Zn-Zr Alloy

Microstructure and Mechanical Properties of Extruded Mg-Zn-Y Alloy

Enhanced Precipitation Strengthening Effect and Ductility of Mg-Gd-Y-Zn-Zr Alloy by Short-Time Solid Solution Prior to Aging

Microstructures and Mechanical Properties of Mg-10Gd-3Y-2Zn-0.5Zr Alloy

Effect of Aging Treatment on the Microstructure, Fracture Toughness and Fracture Behavior of the Extruded Mg-7Gd-2Y–1Zn-0.5Zr Alloy

Effect of Thermo-Mechanical Treatment on the Microstructure and Mechanical Properties of a Mg–6Gd–2Nd–0.5Zr Alloy

Improving Strength and Ductility of Mg–Gd–Y–Zn–Zr Alloy Simultaneously Via Extrusion, Hot Rolling and Ageing

Microstructure Evolution and Mechanical Properties of High Performance Mg–10Gd–2Y–0·5Zn–0·3Zr Alloy During Heat Treatments

Microstructural evolution and enhanced mechanical properties of Mg–Gd–Y–Zn–Zr alloy via centrifugal casting, ring-rolling and aging

Microstructure and Mechanical Properties of Mg–Gd–Y–Zn–Zr Alloy Sheets Processed by Combined Processes of Extrusion, Hot Rolling and Ageing

Microstructure and Strengthening Mechanism of a Thermomechanically Treated Mg–10Gd–3Y–1Sn–0.5Zr Alloy

Effects of extrusion process on microstructure, precipitates and mechanical properties of Mg-Gd-Y-Zr-Ag alloys

Synergic Effects of Gd and Y Contents on the Age-Hardening Response and Elevated-Temperature Mechanical Properties of Extruded Mg–Gd(-Y)-Zn-Mn Alloys