Abstract:Enhanced precipitation strengthening effect and ductility of Mg-9.8Gd-3.6Y-2.2Zn-0.4Zr alloy are achieved by short-time solution treatment prior to aging, and the effects of short-time solution on microstructure differences, strengthening contribution and fracture behavior are analyzed. The IF (initial-forged state) and PA (peak-aged state) samples exhibit the similar microstructure, with numerous fragmented lamellar LPSO phase distributed within the matrix and relatively uniform small grains (∼9μm). The significant increase in grain size of SS (solid solution state) and SSPA (solid solution + peak-aged state) samples (23.1μm and 27.0μm) is related to the lack of “pinning effect” caused by the dissolution of fragmented lamellar LPSO phase, meanwhile, the fully excited static recrystallization during the solution process results in high recrystallization fraction (above 95%) for both the two samples. The σgb (grain boundary strengthening) and σss (solid solution strengthening) contribute more than 70% in both IF and SS samples, while σgb and σpp (precipitation strengthening) dominate in the PA and SSPA samples. The stronger precipitation strengthening effect and age-hardening response of SSPA sample are derived from the more and denser β' precipitates within the matrix. The deformation mechanism of PA sample is the grain boundaries sliding of fine-sized grains and the slip of blocky LPSO phase, the microcracks are mainly concentrated at the grain boundaries, the blocky LPSO phase and its interface with matrix. As a comparison, the tensile deformation mechanism of SSPA sample is sufficient intragranular slip, the microcracks are mainly concentrated at the blocky LPSO phase and extend into the matrix, and finally forming large-sized cracks and deep fracture holes, which enhances the ductility. This paper may provide new ideas for the aging process design of wrought Mg-Gd-Y-Zn-Zr alloys.

Effect of Pack-Forging on Microstructure and Properties of Mg-Gd-Y-Zn-Zr Alloy

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Microstructure evolution and mechanical properties of Mg-Gd-Y-Ag-Zr alloy fabricated by multidirectional forging and ageing treatment

Microstructures and Tensile Properties of Mg-6Gd-3Y-1.4Zn-0.4Zr Alloys

Effect of Forging Temperature on the Microstructure, Subsequent Aging Precipitation Behavior, and Mechanical Properties of Mg-Gd-Y-Zr-Ag Alloy

Improving Strength and Ductility of Mg–Gd–Y–Zn–Zr Alloy Simultaneously Via Extrusion, Hot Rolling and Ageing

Enhanced Mechanical Properties of Mg-Gd-Y-Zn-Mn Alloy by Tailoring the Morphology of Long Period Stacking Ordered Phase

Achieving Enhanced Mechanical Properties in Mg-Gd-Y-Zn-Mn Alloy by Altering Dynamic Recrystallization Behavior Via Pre-Ageing Treatment

Microstructures and Mechanical Properties of Mg–10Gd–6Y–2Zn–0.6Zr(wt.%) Alloy

Microstructures and Mechanical Properties of Mg-10Gd-3Y-2Zn-0.5Zr Alloy

Effect of precipitates on microstructures and properties of forged Mg-10Gd-2Y-0.5Zn-0.3Zr alloy during ageing process

Evolution of the Microstructure and Mechanical Properties of Mg-10Gd-2Y-0.5Zn-0.3Zr Alloy during Extrusion and Aging Processes

Enhanced Precipitation Strengthening Effect and Ductility of Mg-Gd-Y-Zn-Zr Alloy by Short-Time Solid Solution Prior to Aging

Deformation Behavior of Ultra-Strong and Ductile Mg-Gd-Y-Zn-Zr Alloy with Bimodal Microstructure

High Strength Mg-1.4Gd-1.2Y-0.4Zn Sheet and Its Strengthening Mechanisms

Effect of Heat Treatment on the Microstructure and Mechanical Properties of a Multidirectionally Forged Mg-Gd-Y-Zn-Zr-Ag Alloy

Effects of Nanoprecipitates and LPSO Structure on Deformation and Fracture Behaviour of High-Strength Mg-Gd-Y-Zn-Mn Alloys

Microstructure, Texture Evolution and Mechanical Properties of a Large-Scale Multidirectionally Forged Mg-Gd-Y-Zn-Zr-Ag Alloy

Inhomogeneous microstructure and mechanical anisotropy of multi-directional forged Mg-Gd-Y-Zn-Ag-Zr alloy

Effect of LPSO and SFs on Microstructure Evolution and Mechanical Properties of Mg-Gd-Y-Zn-Zr Alloy

Microstructure and mechanical properties of Mg-Gd-Zn-Zr alloy after hot extrusion