Abstract:High-energy ball milling represents an efficient process for producing composite powders consisting of ceramic particles dispersed in a metallic matrix. However, collision events, plastic deformations, and cold welding during the milling lead to a flake or block-like shape of the resulting composite powders. Further consolidation of such irregularly shaped powders by powder bed-based additive manufacturing technologies can be challenging because of their low flowability and low bulk density. In this work, different approaches, including milling process parameters (speed, process control agent atmosphere) and post-treatments (mechanical and thermal), are investigated on their suitability to influence the particle shape, especially concerning the roundness of the composite powders consisting of the aluminum alloy AlSi10Mg with 5 vol% SiC and Al2O3 reinforcement. It is found that milling with menthol as a process control agent leads to the finest composite powder compared to other milling parameters, with the lowest particle roundness of 0.39 (initial powders 0.84). No success in rounding the milled composite powder could be achieved through mechanical post-treatment in a planetary ball mill. On the other side, the thermal spraying of, e.g., SiC reinforced AlSi10Mg powder resulted in a 77–82% relative roundness. A remarkable change in the microstructure and the shape of the composite powders could also be observed after heat treatment in tube furnaces at a temperature above the melting point of AlSi10Mg. The best result in terms of improved roundness (relative to around 85%) was obtained for Al2O3 reinforced at 600 °C. A further increase of the temperature to 700 °C resulted in a moderate coarsening of powders with Al2O3 and extensive sintering of powders with SiC, presumably due to a different distribution inside the matrix.

Ultrasonic Preparation of Submicron Low Melting Point Alloy Powder

Size Dependent Phase Transformation in Atomized TiAl Powders

Preparation of Nb 3 Al Superconductor by Powder Metallurgy and Effect of Mechanical Alloying on the Phase Formation

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Preparation of Nano-aluminum Powder in AlCl3-EMIC Ionic Liquid

Preparation of ti-al based nanophase composite powder by mechanical alloying

Rapid Multiple Slurry-Preparation Technology of Melt Treatment and Reversible Electromagnetic Stirring

Novel Cold Crucible Ultrasonic Atomization Powder Production Method for 3D Printing

A Method for the Preparation of Spherical Titanium Powder for Additive Manufacturing

Influences of Master Alloys and Their Preparation Conditions on Microstructures of Semi-solid A356 Alloy Slurries

Production of Spherical TiAl Alloy Powder by Copper-Assisted Spheroidization

A nanograins-attached and ultrathin Cu flake powder fabricated by high energy mechanical milling and dealloying

Centrifugal Atomization Substrate Quenching Of Rapidly Solidified Particles

3D characterization of ultrasonic melt processing on the microstructural refinement of Al-Cu alloys by synchrotron X-ray tomography

Effect of ultrasonic melt processing and cooling rate on microstructure evolution of Al–Cu–Mn–Mg–Fe–Si alloy

The numerical research on the effect of ultrasonic field on metallic powders produced by the ultrasonic-assisted electrical discharge process

Influencing the Size and Shape of High-Energy Ball Milled Particle Reinforced Aluminum Alloy Powder

A novel ultra-low current and temperature controlled electrochemical method for exposing various kinds of secondary phase precipitates: Application to the sample preparation of zirconium alloys and some other common alloys

Effects of ultrasonic vibration on the microstructure and mechanical properties of high alloying TiAl

Flexible Powder Production for Additive Manufacturing of Refractory Metal-Based Alloys

Comparison of ultrasonic and other atomization methods in metal powder production