Abstract:For inspection of mechanical properties and integrity of critical components such as integrated circuits or composite materials by acoustic methodology, it is imperative to evaluate their acoustic reflection coefficients, which are in close correlation with the elastic properties, thickness, density, and attenuation and interface adhesion of these layered structures. An experimental method based on angular spectrum to evaluate the acoustic coefficient as a function of the incident angle, θ, and frequency, ω, is presented with high frequency time-resolved acoustic microscopy. In order to achieve a high spatial resolution for evaluation of thin plates with thicknesses about one or two wavelengths, a point focusing transducer with a nominal center frequency of 25 MHz is adopted. By measuring the V(z, t) data in pulse mode, the reflection coefficient, R(θ, ω), can be reconstructed from its two-dimensional spectrum. It brings simplicity to experimental setup and measurement procedure since only single translation of the transducer in the vertical direction is competent for incident angle and frequency acquisition. It overcomes the disadvantages of the conventional methods requiring the spectroscopy for frequency scanning and/or ultrasonic goniometer for angular scanning. Two substrates of aluminum and Plexiglas and four stainless plates with various thicknesses of 100 μm, 150 μm, 200 μm, and 250 μm were applied. The acoustic reflection coefficients are consistent with the corresponding theoretical calculations. It opened the way of non-destructive methodology to evaluate the elastic and geometrical properties of very thin multi-layers structures simultaneously.

An Improved Approach for Normal-Incidence Sound Transmission Loss Measurement Using a Four-Microphone Impedance Tube

Measurement of acoustic properties for passive-material samples using multichannel inverse filter.

Measurement of insertion loss for underwater acoustic passive materials with time reversal technique

Normal Incidence Sound Transmission Loss Evaluation with a General Upstream Tube Wave Decomposition Formula.

Sound Transmission Measuring System Based on Four-microphone Method

An Improved Method on Field Sound Insulation Measurement Using Loudspeaker Source

Acoustic Insertion Loss Measurement Using Time Reversal Focusing

A new technique for the measurement of the normal incidence absorption coefficient using an impedance tube and a single microphone with fixed position

A Novel Technique for the Measurement of the Acoustic Properties of a Thin Linear-Viscoelastic Layer Using a Planar Ultrasonic Transducer

Measurements of the normal incidence sound absorption coefficient for Non-standard sized absorbers in impedance tubes

Simultaneously Measuring Thickness, Density, Velocity and Attenuation of Thin Layers Using V(z,t) Data from Time-Resolved Acoustic Microscopy.

In-situ measurement method of sound transmission loss under an oblique incidence of plane wave

Evaluation of the acoustic and non-acoustic properties of sound absorbing materials using a three-microphone impedance tube

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

The feasibility of building an impedance tube to measure sound absorption coefficients of materials

Development of Impedance Tube to Measure Sound Absorption Coefficient

High-frequency measurement method of normal-incidence sound absorption coefficient with a square cross-section impedance tube using eight microphones

Bayesian estimations of dissipation, sound speed, and microphone positions in impedance tubes

Characterization of acoustic materials at arbitrary incidence angle using sound field synthesis

Improving sound insulation near ring and coincidence frequencies of cylindrical sandwich shells