Abstract:With advantages of non-contact, high energy density and local heating, the laser jet solder ball bonding (SBB) technique provides a flexible packaging method for three dimensional (3D) package structure and temperature sensitive components. In previous works, the microstructure and reliability of solder joints fabricated by laser jet SBB were studied. In recent studies, the essential factors influencing the wettability of the molten solder on the bonding pad in flux-free laser jet SBB process were investigated deeply, and the results revealed that the thick oxidation layer of solder balls and the severe contamination of surface of Au bonding pads can lead to the poor wetting. Meanwhile, the corresponding mechanism of the poor wetting was also discussed and analyzed. However, some other important factors causing the reliability degradation even failure of solder joints are still unclear in the laser jet SBB process, for example, the burning failure of electronic components induced by the laser beam. Thus, how to prevent this type failure becomes a tough task for mass production. In this study, from the point of view of the laser characteristics, the essential factors leading to the burning failure have been clarified through microanalysis by using scanning electron microscopy (SEM) and optical microscope (OM). Firstly, the homogeneity of the laser beam was characterized by a laser pro filer. Then, in order to determine the correlation between the burning failure and the transporting characteristics of the laser beam, the different displacements of the nozzle along horizontal (x) and vertical (z) directions were preset, and the burning points in the electronic components were confirmed by using OM and SEM. In addition, the reflection of the laser beam caused by the near spherical solder ball was also studied. The results show that the energy distribution of the laser beam is inhomogeneous and some laser micro-beam has higher energy. Meanwhile, the reflection of the laser beam occurs very commonly in laser jet SBB process, not only the Au bonding pad, but also the solder ball can reflect the laser beam. When a reflecting laser micro-beam contacts to the weak interface of the electronic components with sufficient energy density, the burning failure of the component may appear easily.

Study On Solder Bonding Technology And Its Failure Mechanism

Failure Analysis Of Die-Bonding Interfaces Between Led Chip And Heat Sink

Study on die-bonding key technology of UV LED packaging

Effects of Bonding Materials on Optical–Thermal Performances and High-Temperature Reliability of High-Power LED

Effects of Voids on Mechanical and Thermal Properties of the Die Attach Solder Layer Used in High-Power LED Chip-Scale Packages

Reconstruction and Thermal Performance Analysis of Die-Bonding Filling States for High-Power Light-Emitting Diode Devices

Void Formation and Growth at Solder-Bonded Interfaces in HP LEDs

Effects of bonding parameters on the lighting performance of high power LEDs fabricated by thermosonic flip chip bonding

Comparative Study of Die-Attach Materials for LED Die Bonding

Analysis and simulation of thermal characteristic on die bonding materials of power LED

Improvement of high-power LED performance with sintered chip attachment

Failure Analysis Techniques for High Power Light Emitting Diodes

High Strength and Low Thermal Resistance of Die-Bonding Structure for High-Power Light-Emitting Diodes

Potential interconnect technologies for high power LEDs assemblies

Design of high power LED lighting module and high efficiency heat dissipation structure

Research on Localized Induction Heating for LED Packaging

Improved Thermal Performance of High-Power Led by Using Low-Temperature Sintered Chip Attachment

Reliability and Failure Analysis of Electronic Components Induced by the Reflection of Laser Beam in the Laser Jet Solder Ball Bonding Process

Failure-mechanism analysis for vertical high-power LEDs under external pressure

The Research Progress of High-performance & High-power LED: 973 Program "Research on Critical and Fundamental Problems of High Performance LED Manufacture and Equipment" Introduction of Proiect Achievements

Reliability Test and Failure Analysis of High Power LED Packages