Abstract:In this article, an ultralow-power microelectromechanical system (MEMS) lead-free piezoelectric accelerometer digital system is developed. This proposed system is mainly composed of a MEMS lead-free piezoelectric accelerometer and a readout circuit with successive approximation register (SAR) analog-to-digital converter (ADC). In this work, ANSYS software is used to design the structure, and LZO (ZnO: 3 mol% Li) piezoelectric films are deposited by radio frequency (RF) sputtering method, and LZO-based MEMS lead-free piezoelectric accelerometers are developed with an effective bandwidth of about 600 Hz in the 3-dB range through the MEMS process. The proposed readout circuit achieves high linearity and ultralow power consumption by optimizing each operational amplifier (OPAMP) according to the linearity requirement of the whole system. The differential architecture is adopted to deal with the sensed signal for the purpose of reducing the common-mode noise. A proof-of-concept chip is implemented in a 0.18- $\mu \text{m}$ CMOS process. At 1.8-V supply voltage and 100-kS/s sampling rate, the ADC achieves a signal-to-noise-and-distortion ratio (SNDR) of 58.92 dB and a corresponding effective number of bits (ENOB) of 9.5 bits for an input at Nyquist frequency. The power consumption of the ADC is $2.18 \mu \text{W}$ , resulting a figure-of-merit (FoM) of 30.1 fJ/conversion step. Combining with the piezoelectric accelerometer, the accelerometer system can achieve 600-Hz bandwidth with a 142-mV/ ${g}$ sensitivity and the linearity is 0.9998. Finally, this system is applied to the unmanned aerial vehicle to monitor the motor health status and successfully judge whether the motor of the unmanned aerial vehicle is abnormal.

Design of an Accelerometer in Inclination Monitoring of Power Transmission Pole

A New Type of MEMS Accelerometer with Up-Tuning Structure

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Design of Force-Balance Capacitive Accelerometer

Comprehensive Optimization of Pid-Type Closed-Loop Mems Accelerometer System

Optical Design and Analysis of a High Resolution MOEMS Accelerometer Based on Diffraction Grating

Versatile and Effective Design Platform for Surface Acoustic Wave Accelerometers

Design and Realization of Comb-Finger Micromechanical Accelerometer

Design and Development of a Low-Power Wireless MEMS Lead-Free Piezoelectric Accelerometer System

An aerosol deposition based MEMS piezoelectric accelerometer for low noise measurement

Development of a MEMS Piezoresistive High-g Accelerometer with a Cross-Center Block Structure and Reliable Electrode

Noise Analysis and Performance Improvement of a MEMS Fabry-Pérot Seismic Accelerometer

Design and development of ultra-low-power MEMS lead-free piezoelectric accelerometer digital system for unmanned aerial vehicle motor monitoring

Performance Testing of Micro-Electromechanical Acceleration Sensors for Pavement Vibration Monitoring

Structural Design and Testing of a Micromechanical Resonant Accelerometer

Critical Technologies in Design of Micromechanical Resonant Accelerometer

A High-Performance MEMS Accelerometer with an Improved TGV Process of Low Cost

An Optical Interferometry Based MEMS Accelerometer Applicable to Seismic-Grade Measurement

Design and Demonstration of an In-Plane Micro-Optical-Electro-Mechanical-System Accelerometer Based on Talbot Effect of Dual-Layer Gratings

Design and Fabrication Research on a Capacitive Accelerometer