Abstract:Cu/Al composites have the excellent properties of both Cu and Al, and have the properties of light weight and high conductivity, so they have been widely concerned. In this paper, 5-mm-thick Cu/Al composites prepared by the cast-rolling process are used as experimental materials. To reveal the strengthening and toughening mechanisms of the Cu/Al composites, the interfacial structure, micro-morphology, stress-strain condition, and GND distribution of Cu/Al composites before and after deformation were characterized utilizing TEM, TKD, and EBSD. The results show that the submicron intermetallic compounds Al 2 Cu and Al 4 Cu 9 are formed from the casting-rolling Cu/Al composites. After 15% tensile deformation, many gaps occurred in the interface layer, but at the gaps, there was no crack spreading to the Cu and Al layers. Meanwhile, the deformation in different directions occurs in the Cu grains near the interface, forming a dislocation wall, and the entanglement of the dislocation occurs in the Cu layer near the interface, which contributes to the improvement of tensile strength. The Al layer near the interface layer produces kink bands, which helps to improve the ductility of the composites. Besides, due to the action of the hard intermetallic compound layer, with the increase in tensile deformation, a large number of GND are gradually accumulated in the Cu and Al layers near the interface, resulting in remote back stress, which makes the softer Cu and Al layers obtain higher strength. At the same time, the back stress caused by GND will induce strain hardening, which helps to maintain ductility, so that Cu/Al composites have higher plastic deformation ability while improving mechanical properties.

Deformation Behavior of Brittle/ductile Multilayered Composites under Interface Constraint Effect

Tensile Properties and Fracture Mechanism of the Ti2AlC(0001)/TiAl(111) Interface: Insights from a First-Principles Study

Atomic-scale deformation mechanisms of nano-polycrystalline Cu/Al layered composites: a molecular dynamics simulation

Role of interfaces in the deformation behavior of lamellar TiAl-based alloys with CPFEM simulation

In-situ investigation of deformation behavior and fracture forms of Ti/Al/Mg/Al/Ti laminates

Molecular dynamics studies of the effect of intermediate Fe layer thickness on the enhanced strength and ductility of Cu/Fe/Ni multilayer

Fabrication of Al/Al-TiB 2 laminate composites via hot press sintering process: An insight into the mechanical properties and fracture behavior

Interface regulation effects on mechanical behavior of heterostructure Ti6Al4V/TiAl-based laminated composite sheets

Unraveling hot deformation behavior and microstructure evolution of nanolamellar TiAl/Ti3Al composites

Microstructure and Mechanical Properties of Ti-Al-Ti-Ti2AlNb Laminated Composites Based on the Ductile-brittle Structure

Effect of Al2Cu constituent layer thickness discrepancy on the tensile mechanical behavior of Cu/Al2Cu/Al layered composites: A molecular dynamics simulation

Microstructure evolution and damage mechanism of layered titanium matrix composites under tensile loading

Tensile properties and fracture mechanism of the Ti 2 AlC(0001)/TiAl(111) interface: Insights from a first-principles study

In-situ synchrotron X-ray micro-diffraction investigation of ultra-low-strain deformation microstructure in laminated Ti-Al composites

In-situ investigation on tensile properties of a novel Ti/Al composite sheet

The role of β-titanium ligaments in the deformation of dual phase titanium alloys

Temperature-dependent reversed fracture behavior of multilayered TiBw/Ti–Ti(Al) composites

Interface structure and tensile failure behaviour of novel SiC f /Ti–Ti 2 AlNb hybrid laminated composite material

Study on strengthening and toughening mechanisms of cu/Al composites dominated by interface layer

Phase-field modeling of ductile fracture in bioinspired interfaces with dissipative structures

Interface microstructure effects on dynamic failure behavior of layered Cu/Ta microstructures