Abstract:The metastable-β Ti-55531 alloys with different second phases were chosen to investigate coupling effect of second phase and interface as well as the dislocation interaction details under uniaxial compression. In Ti-55531 alloy, nanoscale ω phase was acquired by solution treatment, which was coherent with the β matrix. The orientation relationship between hexagonal ω and bcc β lattice was (0001)ω//(111)β and [112‾0]ω//[1‾10]β. Sub-microscale α phase was acquired by ageing process, following the Burgers orientation relationship (BOR), {110}β//{0001}α and <11‾1>β//<112‾0>α. The characters of mechanical behaviors and deformation microstructures in this alloy have been analyzed by combining the results from uniaxial compression, scanning electron microscopy (SEM), transmission electron microscopy (TEM) and high-resolution TEM. Ti-55531 alloy micropillars with deformable α phase show great plastic stability and high strength, which are attributed to the deformable α phase and the interaction between the dislocations and the high-density α/β interface. However, Ti-55531 alloy micropillars with nanoscale ω phase exhibit size effect and poor plastic stability. The deformation mechanism of the Ti-55531 pillars with ω phase is dislocation shearing the ω phase, which will cause the ω→β phase transformation. The ω-free channels result in the collective movement of dislocations, performed as the strain bursts in the stress-strain curves. But the dislocation slip between the α phase and the β matrix follows a harmony slip mode, which is similar to “slip relay” behaviour. The results reveal that tuning the morphology of phase interface and the density of second phase to govern the activation, multiplication and movement of dislocation is an effective method to tailor the strength and plastic deformation of materials. The deformation model between the dislocations and the phase interface has great significance to the design of the high performance materials by optimizing the microstructures.

The role of β-titanium ligaments in the deformation of dual phase titanium alloys

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Achieving Enhanced Tensile Strength-Ductility Synergy Through Phase Modulation in Additively Manufactured Titanium Alloys

In-Situ Study on Tensile Deformation and Fracture Mechanisms of Metastable β Titanium Alloy with Equiaxed Microstructure

Slip Analysis and Mechanical Deformation Behavior in Dual-Phase Titanium Alloy: Integrating Crystal Plasticity Simulations with In-Situ Micro-Compression

Investigation of Strain Partition Behavior in the Lamellar Microstructure of Dual-Phase Titanium Alloy Based on Crystal Plasticity Simulations

Recent Advances on the Deformation Behavior of Two-Phase α+β Titanium Alloys

Using transmission Kikuchi diffraction to characterise α variants in an α + β titanium alloy

Phase Composition Effects on Dynamic Behavior and Strain Rate Sensitivity in Metastable β-Ti Alloys

Orientation effect on / phase interface mediated deformation mechanism in titanium alloy

Twinning and Sequential Kinking in Lamellar Ti-6Al-4V Alloy

Slip Behavior of Bi-modal Structure in a Metastable Β Titanium Alloy During Tensile Deformation

Role of interfaces in the deformation behavior of lamellar TiAl-based alloys with CPFEM simulation

Constitutive Behavior of Titanium Alloy with Dual-Phase Microstructures: Experiments and Modeling

Quantification of α phase strengthening in titanium alloys: Crystal plasticity model incorporating α/β heterointerfaces

Crystal Plasticity Finite Element Study of Incompatible Deformation Behavior in Two Phase Microstructure in Near Β Titanium Alloy

Two Kinds of Α/β Phase Transformations and Enhanced Strengths of the Bonded Interface in Laminated Ti Alloys

Deformation mechanisms in the α phase of the Ti-6Al-2Sn-4Zr-2Mo titanium alloy: in situ experiments and simulations

In-situ investigation on the anisotropic behavior of the additively manufactured dual-phase Ti-6Al-4V alloy

Effect of phase boundary on the critical resolved shear stress and dislocation behavior of dual-phase titanium alloy

Coupling Effect of Second Phase and Phase Interface on Deformation Behaviours in Microscale Ti-55531 Pillars