Abstract:A high sensitivity liquid refractive index (RI) sensor based on a single mode fiber-multimode fiber-tapered thin-core fiber-single mode fiber (SMTTS) structure is simulated by the beam propagation method (BPM). The modal interference between core and cladding mode happened because of modal mismatch and the transmission spectrum is calculated by BPM. The approximate linear relationship between liquid RI and spectrum dip wavelength shifts is obtained to demodulate RI value. To make a comparison, transmissions of single mode fiber-thin-core fiber-single mode fiber (STS) as well as single mode fiber-multimode fiber-thin-core fiber-single mode fiber (SMTS) are also calculated. It is significantly shown that the interference is improved by the segment of multimode fiber (M_MF). And the tapered thin-core fiber (TCF) has the functions that not only further can enhance the fringe visibility, but also can increase the RI sensitivity, which is higher with the thinner thin-core taper diameter. When the taper diameter is 53.51m, the average RI sensitivity could reach up to -116.7nm/RIU within the RI range of 1.33 to 1.39. This is much higher than the value of SMTS structure. And in the practice application, it could be a slimmer taper in the SMTTS structure to improve the sensitivity just achieving by a simple fabrication process. All process could be finished using fusion splicer, cutter and hydrogen flame.

Refractive Index Sensor Based on Multimode Interference in a Twin-Hole Fiber

Refractive Index Sensor Based on a Microhole in Single-Mode Fiber Created by the Use of Femtosecond Laser Micromachining

A Reflective Fiber-Optic Refractive Index Sensor Based on Multimode Interference in A Coreless Silica Fiber

Highly Sensitive Refractive Index Sensor Based on Novel Mach–Zehnder Interferometer with Multimode Fiber–thin Core Fiber–multimode Fiber Structure

A Compact Refractive Index Sensor with High Sensitivity Based on Multimode Interference

Refractive index sensors based on the fused tapered special multi-mode fiber

Folded-tapered multimode-no-core fiber sensor for simultaneous measurement of refractive index and temperature

High Sensitivity Refractive Index Sensor Based On Tapered Thin-Core Fiber

Dual Mach–Zehnder Interferometer Based on Side-Hole Fiber for High-Sensitivity Refractive Index Sensing

Novel Intensity-demodulated Fiber-optic Refractive Index Sensor Based on Splicing Point Tapered Fiber

Optical Refractive-Index Sensor Based on Dual Fiber-Bragg Gratings Interposed with a Multimode-Fiber Taper

Slight-Offset Tapered Multimode Fiber with High Sensitivity for Low Refractive Index Range

Simultaneous Measurement of Refractive Index and Temperature with High Sensitivity Based on a Multipath Fiber Mach-Zehnder Interferometer

Temperature-insensitive Refractive Index Sensor Based on an Optical Fiber Extrinsic Fabry–Perot Interferometer Processed by a Femtosecond Laser

High Sensitivity Refractive Index Sensor based on a Tapered Single-mode-Multimode-Single-mode Fiber Structure

Highly Sensitive Refractive Index Sensor Based on a Cladding-Etched Thin-Core Fiber Sandwiched Between Two Single-Mode Fibers

Multimode Interference Refractive Index Sensor Based on Coreless Fiber

Research on High Sensitive Refractive Index Sensor Based on D-Single Mode Fiber

Intensity Modulated Refractive Index Sensor Based on Optical Fiber Michelson Interferometer

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

Temperature-Compensated Refractive Index Sensor Based on Bent-Fiber Interference