Abstract:In order to achieve a high-precision synchronous detection of two different refractive index (RI) analytes, a D-type surface plasmon resonance (SPR) photonic crystal fiber (PCF) RI sensor based on two channels is designed in this paper. The sensor uses a D-shaped planar region of the PCF and a large circular air hole below the core as the sensing channels. Surface plasmon resonance is induced by applying a coating of gold film on the surface. The full-vector finite-element method (FEM) is used to optimize the structural parameters of the optical fiber, and the sensing characteristics are studied, including wavelength sensitivity, RI resolution, full width at half maximum (FWHM), figure of merit (FOM), and signal-to-noise ratio (SNR). The results show that the channel 1 (Ch 1) can achieve RI detection of 1.36-1.39 in the wavelength range of 1500-2600 nm, and the channel 2 (Ch 2) can achieve RI detection of 1.46-1.57 in the wavelength range of 2100-3000 nm. The two sensing channels can detect independently or simultaneously measure two analytes with different RIs. The maximum wavelength sensitivity of the sensor can reach 30,000 nm/RIU in Channel 1 and 9900 nm/RIU in Channel 2. The RI resolutions of the two channels are 3.54 × 10-6 RIU and 10.88 × 10-6 RIU, respectively. Therefore, the sensor realizes dual-channel high- and low-RI synchronous detection in the ultra-long wavelength band from near-infrared to mid-infrared and achieves an ultra-wide RI detection range and ultra-high wavelength sensitivity. The sensor has a wide application prospect in the fields of chemical detection, biomedical sensing, and water environment monitoring.

High Resolution Refractive Index Sensing with Dual-Wavelength Fiber Laser

Refractive Index Sensing Based on Semiconductor Nanowire Lasers

Optofluidic Refractive Index Sensor Based on Partial Reflection

Refractive Index Sensor Based on Tilted Fiber Bragg Grating and Stimulated Brillouin Scattering.

Optical Refractive-Index Sensor Based on Dual Fiber-Bragg Gratings Interposed with a Multimode-Fiber Taper

Refractive Index Sensor Based on Fiber Ring Laser

Refractive Index Sensor Based on No-Core Fiber With Optoelectronic Oscillator Interrogation

Sensitive refractive index sensor based on an assembly-free fiber multi-mode interferometer fabricated by femtosecond laser

Highly sensitive refractive index sensor with fiber in-line Fabry-Perot interferometers based on vernier effect

Side-Polished DBR Fiber Laser with Enhanced Sensitivity for Axial Force and Refractive Index Measurement

Refractive Index Sensors Based on a Chirped Core Long-Period Fiber Grating

Optical Fiber Sensor Based on Capillary Wall for Highly-Sensitive Refractive Index Measurement

Temperature-insensitive refractive index sensor based on high-order-resonance short-line long-period fiber grating

High-Sensitivity Refractive Index Sensor with Dual-Channel Based on Surface Plasmon Resonance Photonic Crystal Fiber

Femtosecond laser fabricated all-optical fiber sensors with ultrahigh refractive index sensitivity: modeling and experiment

Highly Sensitive Refractive Index Sensor Based on a Cladding-Etched Thin-Core Fiber Sandwiched Between Two Single-Mode Fibers

High Sensitivity Evanescent Field Refractometer Based on Modal Interference in Micro-Capillary Wall

An Optical Sensor Designed From Cascaded Anti-Resonant Reflection Waveguide and Fiber Ring-Shaped Structure for Simultaneous Measurement of Refractive Index and Temperature

Refractive Index and Temperature Sensor Based on D-Shaped Fiber Combined With a Fiber Bragg Grating

Refractive index sensors based on the fused tapered special multi-mode fiber