Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Industrial furnace sulfur trioxide pre removing and denitration device and method

Desulfurization and denitration integrative process for coke oven flue gas using dual ammonia solution:from laboratory to industrial test

SCR (selective catalytic reduction) denitration catalyst for accelerating ammonium hydrogen sulfate decomposition by low-temperature flue gas, preparation method and application

Device and method for removing sulfur trioxide from coal-fired flue gas

Denitration catalyst containing tungsten tin manganese cerium composite oxide as well as preparation and application of denitration catalyst

Co-precipitation preparation method of composite oxide denitration catalyst

Low temperature denitration and synergetic desulfurization active carbon catalyst and preparation method thereof

Method for extracting and separating metallic oxide from flue gas denitration catalyst

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Cascade and deep coal-fired flue gas SO removal system and method

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

Integrated technology for dust removal and denitration of high-temperature flue gas in coal-fired power plants

RESEARCH STATUS OF LOW-TEMPERATURE DENITRIFYING CATALYSTS

An efficient and economic denitration technology based on fuel pretreatment for cement cleaner production

Enhancing Simultaneous Desulfurization and Denitrification Efficiency of Cement Kiln Exhaust Gas Via Co-Catalytic Fenton Oxidation Process

Simultaneous removal of SO2 and NO using a spray dryer absorption (SDA) method combined with O3 oxidation for sintering/pelleting flue gas

Double-tower ammonia desulfurization device

Formation mechanism,effects and prevention of NH4HSO4 formed on the surface of V2O5 based catalysts

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Cu SSZ 13 molecular sieve based catalyst adopting core shell structure as well as preparation and application of catalyst

An improved Wellman-Lord process for simultaneously recovering SO2 and removing NOX from non-ferrous metal smelting flue gas