An improved Wellman-Lord process for simultaneously recovering SO2 and removing NOX from non-ferrous metal smelting flue gas

Feng Shi,Kan Li,Diwen Ying,Jinping Jia,Naiqiang Yan,Xiaojing Zhang

DOI: https://doi.org/10.1016/j.cej.2020.125658

IF: 15.1

2020-11-01

Chemical Engineering Journal

Abstract:<p>An improved Wellman-Lord process is developed with electrochemical reactor, which can effectively recycle and reuse SO₂ and NO_X from flue gas. The process features to (a) remove and recycle NO_X while recovering SO₂ with the process of electrochemical denitrification; and (b) solve the problem of pipeline blockage caused by oxidation by-products with ammonium- wet absorption method. The crystallization temperature of the absorption solution reduces more than 50.0% after NH₄⁺ is gradually added to Na₂SO₃. More than nearly 75.0% of (NH₄)₂SO₄ added can ensure that it does not crystallize under the same conditions. The crystallization temperature decreases 44.16% and 54.69% with the absence of SO₃²⁻ (solute of 20% wt) and HSO₃⁻ (solute of 28% wt), respectively, when the interference concentration reaches 80%. The absorption efficiencies of 5% Na₂SO₃ and 5% (NH₄)₂SO₃ reach 98.18% and 98.47% for SO₂ and 98.38% and 93.44% for NO₂, respectively. Co₃O₄/Ti cathode exhibits nitrate removal efficiency of 93.67% and ammonia generation efficiency of 85.56%. The concentration of nitrate-N reduces 86.30% and ammonia-N increases 71.40% when the reaction proceeds for 11 h with intermittent injection conditions. The effect of pH on nitrogen removal with the presence of ammonium is also studied.</p>

engineering, chemical, environmental

What problem does this paper attempt to address?

The problems that this paper attempts to solve are several key issues in the traditional Wellman - Lord process during the simultaneous recovery of sulfur dioxide (SO₂) and removal of nitrogen oxides (NOₓ) in non - ferrous metal smelting flue gas. Specifically:

1. **Pipe Blockage Problem**: Since sodium sulfite (Na₂SO₃) is oxidized to sodium sulfate (Na₂SO₄) by oxygen in the flue gas, and sodium sulfate is prone to crystallize at low temperatures, resulting in blockage of the transport pipes, which increases the operational difficulty and cost.

2. **Inefficient NOₓ Removal Efficiency**: The traditional Wellman - Lord process has a poor removal effect on nitrogen oxides (NOₓ), especially under low - temperature conditions, and it is difficult to adopt conventional reduction and denitrification technologies.

3. **Complex Regeneration Process**: The regeneration process of the traditional process is complex, with harsh operating conditions and high maintenance costs.

To overcome these problems, the author proposes an improved Wellman - Lord process, which is achieved in the following ways:

- **Introduction of an Electrochemical Reactor**: Use electrochemical reactions to reduce nitrate (NO₃⁻) in the absorption liquid to ammonia (NH₃), thereby improving the NOₓ removal efficiency.

- **Use of Ammonium Salt Absorbent**: Partially replace Na₂SO₃ with (NH₄)₂SO₃ to lower the crystallization temperature of sodium sulfate, prevent pipe blockage, and improve the absorption efficiency.

- **Optimization of Absorption and Regeneration Processes**: By optimizing the composition of the absorption liquid and operating conditions, improve the recovery rate of SO₂ and the removal rate of NOₓ.

In summary, this paper aims to simultaneously achieve efficient recovery of SO₂ and removal of NOₓ through the improved Wellman - Lord process, and solve the problems of pipe blockage, inefficient NOₓ removal, and complex regeneration process in the traditional process.