Abstract:Shanghai Soft-Xray FEL (SXFEL) test facility was designed and built to demonstrate EEHG and HGHG schemes and verify key technologies for the future hard xray FEL facility (SHINE). After three years commissioning 8.8 nm FEL radiation with peak power of 1 MW had been achieved at the end of 2019. The design, fabrication, commissioning and operation of BI system including striplineBPM, Cavity-BPM, screen monitor, bunch length monitor, beam arrival monitor, bunch energy monitor, will be introduced in this paper. Several lessons learned during design stage and beam commissioning stage, such as radiation damage of CCDs and step-motors, bad choice of CBPM working frequency, thermal drift of BAM and so on, will be addressed as well. INTRODUCTION SXFEL Test Facility (SXFEL-TF) was initiated in 2006 and founded in 2014. Its 0.84GeV linac and undulators were installed through 2016 to 2018, it is for testing the cascaded seeding schemes. The main parameters are listed in Table 1. The SXFEL-TF commissioning has completed this year, and the SXFEL user facility (SXFEL-UF) is under construction. The layout of SXFEL-TF and SXFEL-UF are shown in Figure 1. Table 1: SXFEL-TF Parameters Parameter Value Total length 293m Electron energy 0.84 GeV Bunch charge 0.5 nC Repetition rate 10 Hz FEL output 8.8 nm FEL scheme HGHG/EEHG FEL pulse 100-200 fs FEL power >100 MW Figure 1: Layout of SXFEL-TF (top) and SXFEL-UF (bottom). In order to maintain high FEL gain, high performance beam instrumentation system is required for the SXFELTF. Measured beam parameters including bunch charge, beam position (BPM), beam profile, beam arrival time (BAM) and bunch length (BLM). Table 2 lists the beam diagnostic devices included and the required resolution. Table 2: Requirements of SXFEL-TF Diagnostic System

HYBRID method simulations of a soft X-ray beamline

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Applications for Synchrotron Radiation in Inertial Confinement Fusion Research

Beam instrumentation system for shanghai soft x-ray fel test facility*

Integrated optical design method for the synchrotron radiation beamlines

Simulation of X-ray Hartmann Wavefront Sensing with the Synchrotron Radiation Workshop

An X-ray beam profile monitoring system at a beamline front-end combining a single-crystal diamond film and energy discrimination using droplet analysis

A beam position monitor and slit combination for synchrotron radiation

Evaluation of the X‐ray/EUV Nanolithography Facility at AS through wavefront propagation simulations

Hybrid Photoelectron Momentum Microscope at the Soft X-ray Beamline I09 of the Diamond Light Source

Evaluation of X-ray/EUV Nanolithography Facility at AS Through Wavefront Propagation Simulations

Measuring academic productivity in spine surgery: in reply.

Hard X-ray optics simulation using the coherent mode decomposition of Gaussian Schell model

A Virtual Young's Double Slit Experiment for Hard X-ray Photons

Performance of the undulator based ultraviolet and soft x-ray beamline for catalysis and surface science at National Synchrotron Radiation Laboratory

New evaluation beamline for soft x-ray optical elements

Simulation of wavefront propagation in diffraction of XFEL beams by single crystals

Quantitative Research on Higher Order Harmonics in Metrology Beamline

Coherence analysis of beamline and simulation of coherent X-ray diffraction imaging based on a coherent modes model