Abstract:beta-Si3N4 with completeness of phase transformation and pole-liked morphology was developed by means of heating the initial Si3N4 powder with certain additive of Lu2O3. The influence of Lu2O3 on phase transformation and seeds morphology was investigated. The result showed that the beta-Si3N4 seeds with up to 95% beta phase content could be gotten with 1 mol% Lu2O3 as additive contents at 1750 degrees C for 2 h. The microstructure and mechanical properties of hot-pressed Si3N4 ceramics, using 10 mol% of Lu2O3 additives were investigated by means of MTS measurements and Vickers indentation crack size measurements, as well as XRD and SEM. It was known that the high fracture toughness of Si3N4 ceramics was attributed to the rodlike morphology of beta-Si3N4 grains. And the reinforcement effect and mechanism of beta-Si3N4 seed were studied. It was found that the grain size and its distribution influence on the property and microstructure of Si3N4 ceramics were investigated. The improvement in the fracture toughness with the amount of additive was mainly attributed to elongated grain growth during the sintering process. By this method, self-reinforced Si3N4 ceramics with an increment of 10 similar to 20% of fracture toughness was fabricated.

Effect of Sm2o3 Additives on the Rod-Like Beta-Si3n4 Crystal of Porous Silicon Nitride Fabricated by Reaction-Bonded

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Effect of Sintering Additives on Microstructure and Mechanical Properties of Porous Silicon Nitride Ceramics

Effects of Sintering Additive and Β-Si3n4 Phase Contents on the Properties of Porous Si3N4 Ceramics

The effects of the single additive on the fabrication of rod-like beta-Si3N4

The Effects of the Single Additive on the Fabrication of Rod-like β-Si3N4

Effects of Sintering Additives on Properties of Porous Silicon Nitride Ceramics Fabricated by Carbothermal Reduction

Effects of α-Si3N4 seeds and sintering additives on properties of porous silicon nitride ceramics fabricated by carbothermal reduction

Influence of Yttria–Alumina Content on Sintering Behavior and Microstructure of Silicon Nitride Ceramics

Effects of MgAl2O4-ZrO2 Addition on Sintering Behaviors and Mechanical Properties of Silicon Nitride Ceramics

Influences of Rare-Earth Oxide Additives on the Formation and Properties of Porous Si2N2O Ceramic

Study on microstructure and mechanical properties of porous Si3N4 ceramics

Effect of Oxide Additives on Catalysis and Microstructure of RBSN Using Low-Purity Silicon Powder As Raw Materials

Effect Of Microstructural Modification On Thermal Conductivity And Strength Of Silicon Nitride

Microstructure and Performance of Silicon Nitride Ceramics with Lu2O3 Additives

Fabrication and characterisation of porous silicon nitride ceramics using Yb2O3 as sintering additive

Fabrication of Porous Silicon Nitride with High Porosity by Diatomite

Effect of MgF2 addition on mechanical properties and thermal conductivity of silicon nitride ceramics

Effect of a New Additive on Mechanical Properties of Hot-Pressed Silicon Carbide Ceramics

The effect of additives on sintering behavior and strength retention in silicon nitride with RE-disilicate

Catalytic Effect of Oxide Additives on Reaction Bonded Silicon Nitride Using Low-Purity Silicon Powder as Raw Materials