Abstract:Gallium oxide (Ga 2 O 3 ), with its ultra-wide bandgap and high breakdown voltage, has emerged as a leading candidate for next-generation power devices. The performance and the Baliga figure-of-merit for power devices critically depend on breakdown voltage sustained by Schottky contact of metal with ultra-wide gap materials. However, high-quality Schottky contacts with Ga 2 O 3 presents a significant challenge due to the presence of surface defects and formation of metal induced mid-gap defects states in Ga 2 O 3 . In this study, we investigate the electrical properties and defects at the interface between Ni metal and β -Ga2O3 thin films. Additionally, a 20 nm MgO thin films with various oxygen contents were deposited on β-Ga 2 O 3 using radio-frequency magnetron sputtering and Ni/MgO/ β -Ga 2 O 3 metal-insulator-semiconductor Schottky diodes were fabricated. The frequency dependent C-V characteristic and surface-sensitive XPS depth profile is employed to study the interface of Ni/Ga 2 O 3 and Ni/MgO/Ga 2 O 3 Schottky barrier diodes. Our results show that the Ni/MgO/Ga2O3 Schottky barrier diode with 66% O2 in the MgO thin film during synthesis attains a barrier height of 0.87 eV. Subsequent post-metallization annealing at 300oC in an Ar ambient for 30 minutes enhances the barrier height up to 1.1 eV. Also, a reduced on-resistance of 11.65 mΩ·cm 2 and a lower on-voltage of 0.3V was obtained after annealing in Ar. The frequency dependent C-V characteristic results show no dispersion in capacitance for the annealed sample which signify the passivation of interface defects density (Δ ιτ ) and oxide charges density (N f ) in the dielectric layer (MgO). The minimum value of D it and N f achieved for the sample having highest barrier height (1.1eV) are 5.41× 10 11 /eV/cm 2 and 2.91×10 10 /cm 3 , respectively. This study establishes a vigorous foundation for the expanded utilization of Ga 2 O 3 in power electronics devices, emphasizing the vital role of interface engineering.

Schottky Barrier Rectifier Based on (100) Ga2O3and its DC and AC Characteristics

Schottky Barrier Rectifier Based on (100) $\beta$ -Ga 2 O 3 and Its DC and AC Characteristics

Schottky Barrier Diode Based On Beta-Ga2o3 (100) Single Crystal Substrate And Its Temperature-Dependent Electrical Characteristics

High Performance Lateral Schottky Diodes Based on Quasi-Degenerated Ga 2 O 3

Low density of interface trap states and temperature dependence study of Ga2O3 Schottky barrier diode with p-NiOx termination

Electrical Characterizations of Planar Ga2O3 Schottky Barrier Diodes

Fabrication of Ga2O3 Schottky Barrier Diode and Heterojunction Diode by MOCVD

2.5kV/3.78mΩ·cm 2 Low Forward Voltage Vertical β-Ga 2 O 3 Schottky Rectifier with Field Plate assisted Deep Mesa Termination

Over 1 GW/cm<SUP>2</SUP> Vertical Ga<sub>2</sub>O<sub>3</sub> Schottky Barrier Diodes Without Edge Termination

A Review of gallium oxide-based Power Schottky barrier diodes

2.5Kv/3.78mω⋅cm² Low Forward Voltage Vertical Β-Ga₂o₃ Schottky Rectifier with Field Plate Assisted Deep Mesa Termination

Ultrawide bandgap vertical β-(AlxGa1−x)2O3 Schottky barrier diodes on free-standing β-Ga2O3 substrates

Over 1 GW/cm 2 Vertical Ga 2 O 3 Schottky Barrier Diodes Without Edge Termination

A 1.6 Kv Ga2O3 Schottky Barrier Diode with a Low Reverse Current of 1.2 × 10−5 A/cm2 Enabled by Field Plates and N Ion-Implantation Edge Termination

-Gao Field Plate Schottky Barrier Diode with Superb Reverse Recovery for High-Efficiency DC–DC Converter

Temperature-dependent Electrical Characteristics of Β–ga2o3 Trench Schottky Barrier Diodes Via Self-Reactive Etching

8.7 A/700 V β-Ga 2 O 3 Schottky barrier diode demonstrated by oxygen annealing combined with self-aligned mesa termination

Interface engineering in epitaxial growth of sputtered β-Ga 2 O 3 films on Si substrates via TiN (111) buffer layer for Schottky barrier diodes

Design and simulation of high performance β-Ga 2 O 3 super barrier rectifier with a current blocking layer

Schottky Rectifiers Fabricated on Bulk Gan Substrate Analyzed by Electron-Beam Induced Current Technique

Interface Engineering for Minimizing Trapped Charge Density in β-Ga2O3 Schottky Barrier Diodes for High-Performance Power Devices