Abstract:In order to achieve the ultra-clean emission standards, many power plants in China have completed the installation of low-low temperature flue gas system. However, during the operation of this system, many problems have emerged, such as the ash deposition problem in the heat exchanger and dry ESP (electrostatic precipitator). In this paper, the fixed adsorption system and entrained flow experimental system were built to study the ash deposition characteristics in low-low temperature flue gas system under different temperatures and particle sizes. The repose angle was measured to evaluate the flowability and adhesion capacity of ash particles. The results show that as the increase of adsorption time, the particle size increased gradually, and the agglomeration effect is attenuated after the particles have reached adsorption saturation. The time at which the ash particles began to agglomerate with each other was defined as the agglomeration threshold. As the adsorption temperature decreased, the particle size growth rate increased. The smaller the size of ash particles, the more significant the agglomeration effect. Large particles were easy to adsorb small particles, but the agglomeration effect between large particles was weak. In addition, in the initial stage of particle agglomeration, it was mainly included the adhesion between smaller particles and the adhesion of smaller particles on the surface of large particles. The followability of the ash particles was greatly reduced after the adsorption and agglomeration process. The repose angle of the ash particles increased as the temperature of the flue gas decreased. The smaller the particle size, the larger the repose angle changes, and the more pronounced the repose angle is influenced by the adsorption temperature. The flue gas temperature cannot be blindly dropped in pursuit of high sulfur oxide removal efficiency and dust removal efficiency.

Theoretical Analysis of Acid Dew Point Temperature and Vapour Condensation Characteristics of the Flue Gas

Prediction of Acid Dew Point in Flue Gas of Boilers Burning Fossil Fuels

Predicting Acid Dew Point with A Semi-Empirical Model

Investigation on Removal Effects and Condensation Characteristics of Condensable Particulate Matter: Field Test and Experimental Study.

Effects of the Changes of Load and Flue Gas Temperature on the Emission of Particulate Matter from the Coal-Fired Unit

Numerical and Experimental Investigation on Water Vapor Condensation in Turbulent Flue Gas

Adsorption and Agglomeration Characteristics of Ash Particles after Reducing Flue Gas Temperature below the Acid Dew Point

Study on characteristics of organic components in condensable particulate matter before and after wet flue gas desulfurization system of coal-fired power plants

Comparison and Analysis on the Calculation Methods of Acid Dew Point of Flue Gas

Prediction of Sulfuric Acid Dew Point Temperature on Heat Transfer Fin Surface

Theoretical Analysis of Flue Gas Exhaust Temperature of White Smoke Elimination Technology for Coal-fired Units

Numerical Study on Acid Condensation and Corrosion Characteristics of Three-Dimensional Finned Tube Surface

The Measurement and Correction of Correlation Formulas of Flue Gas Acid Dew Point

Coupling mechanism of viscose ash deposition and dewpoint corrosion in industrial coal-fired boiler

Study on Spray Condensation Performance of Desulfurization Wet Flue Gas

An Experimental Study on Ash Deposition Problem of Low-Low Temperature Flue Gas System

Emission Characteristics of Filterable Particulate Matter and Condensable Particulate Matter from Coal-Fired Power Plants

Modeling on circulating fluidized bed flue gas desulfurization

Condensation Characteristic of Sulfuric Acid Vapor on Low-Temperature Surface of Tube Heat Exchanger

Numerical Investigation on the Coupling of Ash Deposition and Acid Vapor Condensation on the H-type Fin Tube Bank

Promoting fine particle removal in double-tower cascade wet flue gas desulfurization system by flue gas temperature reduction