Abstract:Surface damage and structure evolution of the full tungsten ITER divertor under transient heat loads is a key concern for component lifetime and plasma operations. Recrystallization caused by transients and steady-state heat loads can lead to degradation of the material properties and is therefore one of the most serious issues for tungsten armor. In order to investigate the thermal response of the recrystallized tungsten under edge localized mode-like transient thermal loads, fully recrystallized tungsten samples with different average grain sizes are exposed to cyclic thermal shocks in the electron beam facility JUDITH 1. The results indicate that not only does the microstructure change due to recrystallization, but that the surface residual stress induced by mechanical polishing strongly influences the surface cracking behavior. The stress-free surface prepared by electro-polishing is shown to be more resistant to cracking than the mechanically polished one. The resulting surface roughness depends largely on the loading conditions instead of the recrystallized-grain size. As the base temperature increases from room temperature to 400 degrees C, surface roughening mainly due to the shear bands in each grain becomes more pronounced, and sub-grains (up to 3 mu m) are simultaneously formed in the sub-surface. The directions of the shear bands exhibit strong grain-orientation dependence, and they are generally aligned with the traces of {1 1 2} twin habit planes. The results suggest that twinning deformation and dynamic recrystallization represent the predominant mechanism for surface roughening and related microstructure evolution.

Surface Mechanical Attrition Treatment of Tungsten and Its Behavior under Low Energy Deuterium Plasma Implantation Relevant to Iter-Divertor Conditions

Vacuum Hot-Pressed Beryllium and Tic Dispersion Strengthened Tungsten Alloy Developments for Iter and Future Fusion Reactors

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Deuterium Blistering in Tungsten and Tungsten Vanadium Alloys

Recent Studies of Tungsten-Based Plasma-Facing Materials in the Linear Plasma Device STEP

Influence of Nitrogen Pre-Irradiation at Different Temperatures on Surface Blistering and Deuterium Retention in Tungsten

Blistering Behavior and Deuterium Retention in Tungsten Vanadium Alloys Exposed to Deuterium Plasma in the Linear Plasma Device STEP

Surface Blistering and Deuterium Retention in Chemical Vapor Deposition Tungsten Exposed to Deuterium Plasma

Influence of Surface Melting on the Deuterium Retention in Pure and Lanthanum Oxide Doped Tungsten

Surface Modification and Deuterium Retention of High Energy Rate Forging W-Y2O3 Exposed to Deuterium Plasma

Enhanced Modification of Tungsten Surface by Nanostructure Formation During High Flux Deuterium Plasma Exposure

Machine learned interatomic potential for dispersion strengthened plasma facing components

Surface Diversifying and Deuterium Retention Characteristics of Doped Graphite with SiC Coating Exposed to Plasma Discharges in EAST Tokamak

Surface Damage and Structure Evolution of Recrystallized Tungsten Exposed to Elm-Like Transient Loads

Surface morphology and deuterium retention in tungsten exposed to high flux D plasma at high temperatures

Surface modification and deuterium retention in hot-rolled potassium doped tungsten alloy exposed to deuterium plasma

Influence of annealing and keV-ion implantation into tungsten on deuterium retention and permeation: The dependence on bulk and surface microstructure

Comparative study of ITER conform tungsten grades exposed to high heat flux and neutron irradiation damage

Tungsten Material Behavior under H2, D2, and He Plasma Interaction Conditions in the Framework of Fusion-Relevant Studies

Microstructural Effects of Y2O3 and TiC Additions in Tungsten

Transient grating spectroscopy of thermal diffusivity degradation in deuterium implanted tungsten