Chaotic mixing performance enhanced by single-wire flexible impeller in stirred vessel

Zuohua LIU,Huiqin XU,Deyin GU,Chuanlin XU,Zhaoming XIE,Changyuan TAO,Yundong WANG

DOI: https://doi.org/10.11949/j.issn.0438-1157.20170674

2017-01-01

Abstract:Mixing power were characterized by torque sensor. The largest Lyapunov exponents were computed by Matlab software. The fluid mixing performances were observed by the fluid field's visualization technology. A comprehensive experimental study on the effects of impeller type, the distance between impeller and bottom, the length of flexible wire, and the diameter of flexible wire on the number of mixing efficiency (Ce), and the largest Lyapunov exponents (LEmax) was carried out. Results showed that, single-wire flexible impeller can regulate and control the flow field structure and the way of energy dissipation, and effectively enhance the chaotic mixing. At rotation speed 120 r·min-1, compared with the traditional rigid impeller, Ce was decreased by 87.4％ and LEmax was increased by 53.2％ with single-wire flexible impeller, Ce was decreased by 43.8％ and LEmax was increased by 10.8％ compared with single-wire rigid impeller. In addition, at the same agitation speed, the longer the flexible wire, the more conducive to the chaotic mixing, but its power consumption would also increase obviously. The diameter of flexible wire was measured at 0.8 mm, while Ce was less than the others and LEmax was larger than the others, which indicated that the degree of chaotic mixing was the largest in the case. Increasing the diameter of flexible wire led to the increase of fluid motion irregularity and the degree of chaotic mixing. If the diameter of flexible wire is more than 0.8 mm, the disturbance of flexible wire was reduced, which was close to the traditional rigid impeller, resulting in the decrease of chaotic mixing characteristics. It was not conducive to fluid mixing while the distance between impeller and bottom was too high or too low, the optimal distance between impeller and bottom was at 0.25T (T was used to express the inner diameter of stirred vessel).