Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Chaotic mixing and dispersing characteristics of gas-liquid two phases in stirred tank

Study on Local Gas-Liquid Dispersion in Dual-Impeller Aerated Stirred Vessel

Design of Impeller Blades for Intensification of Gas-Liquid Dispersion Process in a Stirred Tank

Gas-liquid Mixing Performance, Power Consumption, and Local Void Fraction Distribution in Stirred Tank Reactors with a Rigid-Flexile Impeller

Chaotic mixing performance in rigid-flexible impeller stirred tank with eccentric air jet

Numerical Simulation of Gas-Liquid Dispersion in A Stirred Tank Agitated by Punched Rigid-Flexible Impeller

Chaotic mixing intensified by rigid flexible coupling impeller

Chaotic mixing enhanced by punched-flexible impeller in stirred vessel

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

The Influence of Impeller Combination on the Gas-Liquid Dispersion Performance of a Coaxial Mixer in Viscous Fluids

Chaotic mixing performance enhanced by single-wire flexible impeller in stirred vessel

Oil-water biphase chaotic mixing enhanced by punched rigid-flexible combination impeller in mixer-settler

Intensification of Chaotic Mixing in a Stirred Tank with a Punched Rigid-Flexible Impeller and a Chaotic Motor

Parametric study of gas−liquid two-phase flow field in horizontal stirred tank

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer

Chaotic Mixing Intensification and Flow Field Evolution Mechanism in a Stirred Reactor Using a Dual-Shaft Eccentric Impeller

GAS DISPERSION AND SOLID SUSPENSION IN A THREE-PHASE STIRRED TANK WITH MULTIPLE IMPELLERS

Gas–liquid mixing performance of a non‐Newtonian fluid in a multiple‐impeller agitated tank

Experimental Study of Power Consumption, Local Characteristics Distributions and Homogenization Energy in Gas–liquid Stirred Tank Reactors

Chaotic mixing process of fly ash in acid leaching tank intensified by rigid-flexible impeller

Mixing enhancement of solid-liquid two-phase by coupling double-layer rigid impeller and non-constant chaotic rotating speed