Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Gas-liquid Mixing Performance, Power Consumption, and Local Void Fraction Distribution in Stirred Tank Reactors with a Rigid-Flexile Impeller

Study on Local Gas-Liquid Dispersion in Dual-Impeller Aerated Stirred Vessel

Experimental Study of Power Consumption, Local Characteristics Distributions and Homogenization Energy in Gas–liquid Stirred Tank Reactors

Chaotic mixing and dispersing characteristics of gas-liquid two phases in stirred tank

Design of Impeller Blades for Intensification of Gas-Liquid Dispersion Process in a Stirred Tank

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

The Influence of Impeller Combination on the Gas-Liquid Dispersion Performance of a Coaxial Mixer in Viscous Fluids

Gas–liquid mixing performance of a non‐Newtonian fluid in a multiple‐impeller agitated tank

Numerical Simulation of Gas-Liquid Dispersion in A Stirred Tank Agitated by Punched Rigid-Flexible Impeller

Chaotic mixing performance in rigid-flexible impeller stirred tank with eccentric air jet

Mixing Time in Stirred Tank of Three-phase Gas-Liquid-Floating Particle Systems

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer

Gas-Liquid Floating Particle Mixing in an Agitated Vessel

Gas-Liquid Dispersion and Mixing Characteristics and Heat Transfer in A Stirred Vessel

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

Energy efficiency analysis for high-viscosity fluid mixing enhanced by flexible impeller

Local gas-liquid dispersion properties in a dual-impeller stirred vessel

Experimental Study on Gas–liquid Dispersion and Mass Transfer in Shear-Thinning System with Coaxial Mixer

GAS DISPERSION AND SOLID SUSPENSION IN A THREE-PHASE STIRRED TANK WITH MULTIPLE IMPELLERS