Abstract:Researches of flow and dispersion in urban area are important to meet the practical demands of studies of vehicular exhaust pollution and accidental leakage. Numerical simulations with field observations and physical simulations (e.g., wind tunnel simulation) are often used to address atmospheric flow and dispersion problems in cities. In general, numerical simulations can provide specific detailed informations of flow, turbulence and dispersion. To deal with small-scaled flow and dispersion, computational fluid dynamics (CFD) models are widely applied and are capable of reproducing small-scaled characteristics of flow and dispersion. A CFD model-FLUENT was adopted to simulate the disturbance of a single building on atmospheric flow under the neutral stability condition. Wind tunnel data published by Hamburg University was collected to validate the modeled results and assess the choices of parameters and parameterization schemes. This technique was applied to address atmospheric dispersion problems in quasi-urban building arrays. Concentration data of MUST and a tracer experiment were used to evaluate the dispersion modeling. The results indicated that FLUENT well performed in mean flow simulation under construction disturbance condition. Simulated results for FAC2 of horizontal and vertical modeling wind speed were 77.9% and 61.0% respectively. However, thre was a relatively larger discrepancy between the modeling and measured turbulence characteristics, when the FAC2 of modeling turbulent kinetic energy was 54.6%. The turbulent closure scheme options (i.e., standard K-ε scheme, Re-normalization Group K-ε scheme and Reynolds Stress Model scheme) had trivial effects on simulated results. The dispersion simulation case within quasi-urban buildings was satisfactory. The result of the dispersion case correctly reproduced the irregular plume shifting caused by building disturbance compared to the average wind direction. The modeling concentrations were generally in accordance with measured results, and the relative tolerance of the modeling maximum concentration in lateral profile at 32 and 63 m downwind were 72.5% and 36.9% respectively. Relative to the Gaussian plume model-ISC3, FLUENT can provide more practical concentration distribution under complex conditions. FLUENT simulation also indicated that the maximum lateral concentration decreased along the downwind direction in "step change" pattern between the adjacent street canyons near the release source. The maximum lateral pollutant concentrations in the same street canyon as the source were several times or even one order of magnitude higher than that in the next canyon. FLUENT results can reproduce the phenomena of dispersion towards upwind area and also of accumulation and detouring flow around the constructions. Further researches are required to analyze the phenomena.

Numerical Simulation of Radioactive Material Around Opening-Windows Construction

Simulation of the Concentrations and Distributions of Indoor Radon and Thoron

Numerical investigations on radon migration from building walls into indoor atmosphere under natural convection

Computational fluid dynamics modelling for indoor radioactive pollutant study

Numerical study on the gaseous radioactive pollutant dispersion in urban area from the upstream wind: Impact of the urban morphology

Computational fluid dynamics simulation of wind-driven inter-unit dispersion around multi-storey buildings: Upstream building effect

Numerical Simulation of Indoor Concentration Change of Carbon Dioxide Dispersion under Natural Ventilation Condition

Numerical Simulation of Micro-Environmental Flow Around City Resident Sub-Districts

High-Resolution Simulation of the Near-Field Pollutant Dispersion in a Nuclear Power Plant Community with High-Performance Computing

Numerical analysis and modeling of two-loop experimental setup for measurements of radon diffusion rate through building and insulation materials

A Method for the Assessment of the Inhalation Dose Exposure to Radionuclides in an Indoor Environment

Numerical simulation of flow field characteristics and pollutant transport under different ventilation modes

Numerical investigation of wind-induced airflow and interunit dispersion characteristics in multistory residential buildings

Numerical Simulation and Analysis of Hazardous Gas Dispersion in Urban Sub-Domain

Construction and Validation of an Urban Area Flow and Dispersion Model on Building Scales

Numerical simulation of inter-flat air cross-contamination under the condition of single-sided natural ventilation

CFD Simulations of Flow and Dispersion under Construction Disturbance Conditions

Simulating Flow and Dispersion by Using WRF-CFD Coupled Model in a Built-Up Area of Shenyang, China

Numerical studies on issues of Re-independence for indoor airflow and pollutant dispersion within an isolated building

Numerical Simulation Of The Anthrax Movement In Ventilated Rooms

DIFFUSION LAW AND SIMULATION ANALYSIS OF RADON IN URANIUM TAILINGS BASED ON MULTIPLE GAUSS PLUME MODEL