Abstract:The exploitation of high-voltage GaN power switches enables the development of power converters with superior characteristics with respect to components developed with heritage silicon-based technologies. One of the key advantages of GaN switches is their very fast commutation capability due to reduced parasitic capacitance and inductance with respect to silicon devices. The capability of an accurate evaluation of the switch commutations in the design phase is of crucial importance to maximize performance and avoid reliability or electromagnetic compatibility issues in the final converter. In this paper, an accurate evaluation of high-voltage GaN HEMT commutations is performed, exploiting detailed non-linear dynamic models of transistors and electromagnetic simulations of a PCB. A deep insight into the commutation waveforms in the intrinsic device (i.e., conductive drain current and intrinsic node voltages) is proposed to evaluate and explain the mechanisms of almost lossless turn-off and turn-on commutations in a 7 kW DAB converter. The influence on the performance of the PCB parasitics and the driver characteristics are accurately reproduced by simulations, suggesting important guidelines for the optimal design of power converters fully exploiting GaN HEMT's potential. This detailed simulation/analysis approach for transistor commutation is typically adopted in Radio Frequency amplifier design but also becomes very valuable in power converter design when the very fast commutations of a GaN HEMT at a high switching frequency cannot be fully described and taken under control with conventional approaches used in power electronics design. The simulation results are confirmed by experimental data.

Dual Active Bridge Based on High Voltage GaN Device

A 2–10 MHz GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping and Dual Level Shifters for Automotive Applications

A GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping for High-Frequency DC-DC Converter.

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

ZVS range extension of 10A 15kV SiC MOSFET based 20kW Dual Active Half Bridge (DHB) DC-DC converter

A GaN Based Dual Active Bridge Converter for Energy Storage Systems

A single-stage bidirectional dual-active-bridge AC-DC converter based on enhancement mode GaN power transistor

1-kV Input 1-MHz GaN Stacked Bridge $\textit{LLC}$ Converters

Virtual Prototype and GaN HEMT Based High Frequency LLC Converter Design

Deadband Effect and Accurate ZVS Boundaries of GaN-Based Dual-Active-Bridge Converters With Multiple-Phase-Shift Control

System Design of Dual Active Bridge (DAB) Converter Based on GaN HEMT Device

A Monolithic GaN Power Stage with Low Propagation Delay and High Reliability Level Shifting for High Frequency Power Converter.

Design and Optimization of a Current-Driven Phase-Shift Full-Bridge Converter with GaN Devices and Large Conversion Ratio

A 1-Mhz ZVS Boost DC-DC Converter with Active Clamping Using GaN Power Transistors

Investigation of GaN and Si Based Full-Bridge Converters for DC Motor Drive

Accurate Evaluation of Commutations of 650 V GaN Power Switches Assisted by Electromagnetic Simulations in a 7 kW Dual Active Bridge Converter for Automotive Battery Charging Applications

Design of a High Power Density Bidirectional AC/DC Converter Based on GaN

Analysis and Design of High Frequency Half-bridge Resonant Converter Based on GaN FETs

An Up to 10mhz 6.8% Minimum Duty Ratio GaN Driver with Dual-MOS-Switches Bootstrap and Adaptive Short-Pulse Based High-CMTI Level Shifter Achieving 6.05% Efficiency Improvement

10 Kw High Efficiency Compact GaN-Based DC/DC Converter Design

A 1 MHz Half-Bridge Resonant DC/DC Converter Based on GaN FETs and Planar Magnetics