Abstract:The weak characteristics of high-impedance faults and the complex attributes of cross-country faults make faulty feeder detection of cross-country high-impedance faults difficult in medium-voltage networks. This paper deduces the zero-sequence equivalent circuit of cross-country faults through a three-sequence two-port network, analyzes the influence of grounding resistance on cross-country faults, and then explores the limitations of the traditional passive feeder detection methods. Moreover, this paper proposes a novel faulty feeder detection method for cross-country high-impedance faults based on zero-sequence active power regulation. First, based on the zero-sequence current varying characteristics under the regulation of zero-sequence voltage, construct a continuous adjustment region of zero-sequence voltage within the feeder insulation tolerance range. Next, based on the zero-sequence active power varying characteristics in each feeder, propose a discriminant formula for the zero-sequence active power fluctuation coefficient. Finally, adjusting zero-sequence voltage can actively amplify the differences in zero-sequence active power fluctuations between healthy feeders and faulty feeders and accurately select faulty feeders of cross-country high-impedance faults in medium-voltage networks. Various fault conditions are simulated in the PSCAD/EMTDC simulation and field test to verify the effectiveness of the proposed method. The proposed method can accurately identify all faulty feeders of cross-country high-impedance faults in the medium-voltage distribution network.

Application of approximate entropy to cross country fault detection in distribution networks

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Traveling-Wave Based Fault Location for Phase-to-Ground Fault in Non-Effectively Earthed Distribution Networks

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

Novel Fault Locating Method Based on Synchronized Voltage Phasor

Fault Location Algorithm for HV Transmission Lines Immune to Saturation of Current Transformers

State Estimation Based Fault Location Method for Active Distribution Networks

Earth Fault Detection Method in Non-solidly Earthed Network Based on the Increments of Phase Current

Fault Location Method in Power Network by Applying Accurate Information of Arrival Time Differences of Modal Traveling Waves

Fault Location Method for Distribution Network Based on Synchronous Measurement

A novel fault location method for distribution networks with distributed generations based on the time matrix of traveling-waves

Fault Detection and Location of 35 kV Single-Ended Radial Distribution Network Based on Traveling Wave Detection Method

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

A data-driven method to detect and localize the single-phase grounding fault in distribution network based on synchronized phasor measurement

A two-phase electric quantity-based fault location algorithm for power distribution systems

High-impedance faulty feeder detection for cross-country faults in distribution networks based on zero-sequence active power regulation

Regionalized Fault Line in Distribution Networks Based on an Improved SSA-VMD and Multi-Scale Fuzzy Entropy

Faulty Feeder Detection for Single-Phase-to-Ground Fault in Distribution Networks Based on Transient Energy and Cosine Similarity

Fault Location Method Based on Full Waveform Information for Distribution Networks

Fault location based on variable mode decomposition and kurtosis calibration in distribution networks

Current Sag and Mismatch Based Earth Fault Location for Distribution Network with Renewable Energy Resources