Abstract:(Zr62Cu15.4Ni12.6) (x = 6–12) in situ glassy composites containing uniformly distributed Ta-rich particles were prepared by arc-melting and copper mould casting. The results show that addition of 6–10 at.% Ta to Zr62Cu15.4Ni12.6Al10 results in dissolution of 2.4 to 4.6 at.% Ta in the glassy matrix, which promotes glass-forming ability, and the remaining Ta precipitates out as body-centered cubic (BCC) Ta-rich particles dispersed on the glassy matrix. The critical diameters for the composites with 6, 8, and 10 at.% Ta are 7, 7, and 6 mm, respectively. At 12 at.% Ta addition, the glass-forming ability is dramatically reduced because of the precipitation of secondary dendritic Ta-rich particles and other nanocrystallites from melts during copper mould casting. Also, owing to the solid-liquid reaction during induction heating, some Ta-rich particles formed in the master alloys will redissolve into the glassy matrix, resulting in a smaller volume fraction of Ta-rich particles in the as-cast glassy rods than that of the corresponding ingots. The glassy matrix composites exhibit enhanced plastic strain of about 7.5 to 22.5% at room temperature. The optimum Ta content in the glassy alloys is determined to be 10 at.%, which corresponds to the highest ultimate stress of 2220 MPa and the largest plastic strain of 22.5%. The plastic strain increases with increasing volume fraction of in situ BCC Ta-rich particles. This is apparently ascribed to the impedance of Ta-rich particles to shear bands. Ta-rich particles seed the initiation of multiple shear bands and block the shear band propagation, leading to intensive multiplication and bifurcation of shear bands.

A High-Strength Co–Fe–Ta–B Metallic-Glass Phase Enabled Tensile Plasticity in Co–Fe–Ta–B–O Oxide Glass Matrix Nanocomposites

Size-Dependent Brittle-To-Ductile Transition in Silica Glass Nanofibers

High Tensile Plasticity and Strength of a CuZr-based Bulk Metallic Glass Composite

Fe-based bulk metallic glass matrix composite with large plasticity

Fe-Based Bulk Metallic Glass with High Plasticity

Development of Zr-based metallic glass matrix composites with hybrid reinforcing structures

Minor Cr Alloyed Fe–Co–Ni–P–B High Entropy Bulk Metallic Glass with Excellent Mechanical Properties

Ultra-high strength Co–Ta–B bulk metallic glasses: Glass formation, thermal stability and crystallization

Metallic glass matrix composite with precipitated ductile reinforcement

Formation and ultrahigh mechanical strength of multicomponent Co-based bulk glassy alloys

Improving the glass-forming ability and plasticity of a TiCu-based bulk metallic glass composite by minor Ta doping

High-strength and malleable dual-phase nanostructured Ta-based metallic glass via atomic manufacturing

Development of High Strength Ni–Cu–Zr–Ti–Si–Sn In-Situ Bulk Metallic Glass Composites Reinforced by Hard B2 Phase

High-strength and Ductile Glassy-Crystal Ni–Cu–Zr–Ti Composite Exhibiting Stress-Induced Martensitic Transformation

Improved Tensile Ductility by Severe Plastic Deformation for Nano-Structured Metallic Glass.

Zr-Cu-Ni-Al-Ta Glassy Matrix Composites with Enhanced Plasticity

Multi-functional Amorphous/crystalline Interfaces Rendering Strong-and-ductile Nano-Metallic-glass/aluminum Composite

Structure and properties of Zr–Ta–Cu–Ni–Al bulk metallic glasses and metallic glass matrix composites

Incorporation of ultrafine nanograins in Zr–Cu–Al–Ni–Co bulk metallic glass enabling significantly improved mechanical properties

High-temperature malleable Ta-Co metallic glass developed by combinatorial method

Toughening oxide glasses through paracrystallization